Herunterladen Inhalt Inhalt Diese Seite drucken

Team Kalorik TKG SFC 2000 Bedienungsanleitung Seite 8

Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 12
ASSEMBLY
1.
Attach the flexible hose with the steam gun to the appliance. To do so, flip down the
flap that covers the hose connection inlet and insert the hose connector into the hose
connection inlet until it locks, making sure that the small lug of the hose connector
enters into the small slot at the bottom of the hose connection inlet.
To remove the hose after use, press the release buttons on the sides of the hose
connector and pull at the hose connector.
2.
Unscrew the safety cap: press the safety cap and at the same time turn it
anticlockwise (if there is still water in the tank and if the safety cap was still screwed in
tight for a previous use, some degassing will occur. This is normal and not dangerous).
3.
Fill the water tank with water. Please use the provided measuring cup and the funnel.
If the water in your region is hard, it is advisable to use distilled water or boiled water.
Never fill descaling agent, perfume or detergent into the water tank.
Do not exceed the maximum filling level (1.4 litres).
4.
Lock back the safety cap: press the safety cap and at the same time turn it clockwise.
5.
If you want to clean floors or areas which are difficult to reach, assemble the extension
tubes. To do so, push the open end of a tube onto the steam gun until the release
button of the steam gun clicks into place. You can assemble just one, two or all three
extension tubes.
To remove the extension tubes, press the release button on top of the extension tube
or steam gun and pull the tubes apart.
6.
Put the floor brush on the extension tube until the release button clicks into place.
7.
To use another accessory: assemble the accessory connecting piece by sliding the
accessory connecting piece onto the steam gun or onto the extension tube until the
release button clicks into place. Then assemble the accessory onto the accessory
connecting piece and give it a quarter turn in an anti-clockwise direction to lock it
into place.
To remove the accessory, give it a quarter turn in clockwise direction and pull it off.
TKG MBO 1000
Window wiper : for windows, mirrors, glass doors etc...
Caution! Do not use on cold glass directly.
Curved nozzle : for areas which are difficult to reach (toilets...etc).
Extension tubes : for the extension of the accessories.
8

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis