Herunterladen Diese Seite drucken

Hoftronic 5420573 Bedienungsanleitung

Led flutlicht sensor

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

IP65
FLOODLIGHT SENSOR
5420573
5420603
SKU
5420580
5420610
5420597
5420627
USER MANUAL
BEAM LED
5420634
5420665
5420641
5420658

Werbung

loading

Inhaltszusammenfassung für Hoftronic 5420573

  • Seite 1 IP65 USER MANUAL BEAM LED FLOODLIGHT SENSOR 5420573 5420603 5420634 5420665 5420580 5420610 5420641 5420597 5420627 5420658...
  • Seite 2: Important Safety Details

    IMPORTANT SAFETY DETAILS Ensure the AC/Mains power is NOT connected and cannot be unexpectedly reconnected during installation. 2. This product must be installed by a qualified electrician in accordance with instructions provided and in compliance with recognised electrical and safety regulations relevant to the country it is being installed. This product may NOT be installed by minors or people with a mental disability. Carefully observe all instructions of warnings that are labelled on, or supplied with your product. This product is suitable for outdoor use. If in any doubt, consult a qualified electrician. Please use proper wire for connection. The lenght of output leads should be typically 0.5m-2m in order to keep radio interference minimum. DIAGRAM SPECIFICATIONS Voltage...
  • Seite 3: Installation

    TESTING PIR • Turn the SENS dial clockwise to the maximum point, turn the TIME dial anti-clockwise to the minimum point, turn the LUX dial clockwise to the Sun. • When you switch on the power, the fitting will not illuminate. After a 30 second pre-heat, when the sensor gets the induction signal, the load will turn on. Once the load switches off , it will then turn on again after 5-15 seconds of the sensor receiving an induction signal. • After the sensor goes off, trigger the detection field after 5-10 seconds. The load should work. • When there is no induction signals in the sensor, the load should stop working. • Turn the LUX dial anti-clockwise to the Moon. If it is adjusted to less than 3 LUX (dark), the load and sensor should not work when testing in daylight. If you cover the detection window with an opaque object, the load should work. • Under no induction signal condition, the load should stop working within 5-15 seconds. NOTE: WHEN TESTING IN DAYLIGHT, PLEASE TURN THE LUX DIAL TO THE (SUN) POSITION, OTHERWISE THE SENSOR WILL NOT WORK! 30-50W 100-200W INSTALLATION Install the LED floodlights on the ground, wall or ceiling. This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your local authority or retailer for recycling advise. (Waste Electrical and Electronic Equipment Directive)
  • Seite 4 For more information about Hoftronic products visit www.hoftronic.com. Hoftronic shall not be responsible NEDERLANDS for any damage resulting from the failure to follow these instructions. Hoftronic reserves the right to make changes in the manual - the current version can be downloaded at www.hoftronic.com.
  • Seite 5 Het niet opvolgen van deze instructies kan leiden tot bijvoorbeeld brand, brandwonden, elektrische schokken, lichamelijk letsel en andere materiële en immateriële schade. MILIEUBESCHERMING Meer informatie over Hoftronic producten vindt u op www.hoftronic.com. Hoftronic Hou je omgeving schoon. Segregatie van post-verpakkingsafval wordt aanbevolen. is niet verantwoordelijk voor schade als gevolg van het niet opvolgen van deze Wanneer u het product wilt afvoeren dient u dit op een verantwoorde manier als instructies. Hoftronic behoudt zich het recht voor om wijzigingen in de handleiding...

Diese Anleitung auch für:

542058054205975420603542061054206275420634 ... Alle anzeigen