Werbung
Verfügbare Sprachen
Verfügbare Sprachen
TESTING PIR
•
Turn the SENS dial clockwise to the maximum point, turn the TIME dial anti-clockwise to the minimum point, turn the LUX dial clockwise to
the Sun.
•
When you switch on the power, the fitting will not illuminate. After a 30 second pre-heat, when the sensor gets the induction signal, the load
will turn on. Once the load switches off , it will then turn on again after 5-15 seconds of the sensor receiving an induction signal.
•
After the sensor goes off, trigger the detection field after 5-10 seconds. The load should work.
•
When there is no induction signals in the sensor, the load should stop working.
•
Turn the LUX dial anti-clockwise to the Moon. If it is adjusted to less than 3 LUX (dark), the load and sensor should not work when testing in
daylight. If you cover the detection window with an opaque object, the load should work.
•
Under no induction signal condition, the load should stop working within 5-15 seconds.
NOTE: WHEN TESTING IN DAYLIGHT, PLEASE TURN THE LUX DIAL TO THE (SUN) POSITION, OTHERWISE THE SENSOR WILL NOT WORK!
30-50W
INSTALLATION
1.
4.
Install the LED floodlights on the ground, wall or ceiling.
This product should be disposed of responsibly at the end of its life. Please recycle where facilities exist. Check with your local authority or retailer for recycling advise.
(Waste Electrical and Electronic Equipment Directive)
100-200W
2.
5.
3.
6.
Werbung
