Installation - Klark Teknik DN9650 Schnellstartanleitung

10 DN9650/DN9652
DN9650/DN9652 – Getting Started
Unpacking
This chapter shows you how to prepare the DN965X for operation, which includes unpacking, installation,
connection and confi guration. Please visit klarkteknik.com and download the full Operator Manual for
more information.
Before installing, setting up or operating this equipment, make sure you have read and fully
understand all of the "IMPORTANT SAFETY INSTRUCTIONS" at the front of this document.
Important:
You must set up the IP address and netmask of your computer (PC/Mac) before using it for the
fi rst time.

Installation

When installing the unit, take the following into consideration.
• Do not install the equipment in places of poor ventilation.
• Do not install this equipment in a location subjected to excessive heat, dust or mechanical vibration. Allow
for adequate ventilation around the equipment, making sure that its vents are not obstructed. To prevent
excessive heating of the equipment, avoid mounting it directly above power amplifi ers or other devices
that radiate signifi cant amounts of heat, such as radiators and heaters. Keep the equipment out of direct
sunlight.
• This unit is designed for mounting in any 19" EIA standard rack. Four rack-mount holes in the front panel
are provided for rack mounting and are designed to fully support the weight of the unit in the rack. Avoid
over-tightening the rackmount screws, as this could damage the front panel.
Handling the equipment
Completely isolate the equipment electrically and disconnect all cables from the equipment before moving it.
When lifting or moving the equipment, always take its size and weight into consideration.
Radio frequency interference - Class A device
This equipment has been tested and found to comply with the limits for a Class A digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. Operation of this equipment in a
residential area is likely to cause harmful interference in which case the user will be required to correct the
interference at his own expense.
Electric fi elds
Caution:
In accordance with Part 15 of the FCC Rules & Regulations, "... changes or modifi cations not
expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment."
Should this product be used in an electromagnetic fi eld that is amplitude modulated by an audio
frequency signal (20Hz to 20kHz), the signal to noise ratio may be degraded. Degradation of up to 60dB
at a frequency corresponding to the modulation signal may be experienced under extreme conditions
(3V/m, 90% modulation).
Connecting up the
Making sure that all equipment is switched off , connect the DN965X to the rest of your audio equipment, as
shown in the following diagrams.
DN965X
Video black burst source
DN9650 rear panel
Typical DN9650 audio connection configuration
Video black burst source
DN9652 rear panel
Typical DN9652 audio connection configuration
Quick Start Guide
Word clock target
Word clock source
AES50 connectors
Third party
3-port AES50
(for example, on rear panel of XL8)
network module
Network module A
Midas digital console
(for example, an XL8 control centre)
Word clock target
Word clock source
Third party Third party
network module network module
Network module A Network module B
11