Anker Y1822 Schnellstartanleitung Seite 6

This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 20mm must be
maintained between the user's body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do
not meet these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved antenna.
This device is in compliance with the essential requirements and other relevant
provisions of UKCA. All essential radio test suites have been carried out.
This device was tested for typical body-worn operations. To comply with RF
exposure requirements, a minimum separation distance of 20cm must be
maintained between the user's body and the handset, including the antenna.
Third-party belt-clips, holsters, and similar accessories used by this device
should not contain any metallic components. Body-worn accessories that do
not meet these requirements may not comply with RF exposure requirements
and should be avoided. Use only the supplied or an approved antenna.This
device in compliance with the essential requirements and other relevant
provisions of Directive 2014/53/EU. All essential radio test suites have been
carried out. 1. The device complies with RF specifications when the device used
at 20cm from your body.
Specifications
Adapter Input 100-240V~ 0.5A 50/60Hz
Adapter Output 9V 1.5A, 13.5W
Wireless Output 7.5W Max
Adapter Average active
84.45%
efficiency
80.39%
Adapter Efficiency at low
load (10%)
07
Adapter No-load power
0.06W
consumption
Radiated H-Field 41.12dBuA/m (@3m)
Tx/Rx Frequency Range 115-148KHz
Anker Innovations Limited
Room 1318-19, Hollywood Plaza, 610 Nathan Road, Mongkok, Kowloon, Hong Kong
The following importer is the responsible party (contract for EU and UK
matters)
Anker Innovations Deutschland GmbH
Georg-Muche-Strasse 3, 80807 Munich, Germany
Anker Technology (UK) Ltd
Suite B, Fairgate House, 205 Kings Road, Tyseley, Birmingham, B11 2AA, United
Kingdom
Amazon, Kindle, and all related marks are trademarks of Amazon.com, Inc. or
its affiliates
Product Number: Y1822
Product Name:Anker Wireless Charging Dock for Kindle Paperwhite (Signature
Edition)
Indoor use only
This symbol indicates that this product shall not be treated as
household waste. Instead it shall be handed over to the applicable
collection point for the recycling of electrical and electronic
equipment.
08