Bayco NightStick XPR-5586 Gebrauchsanleitung

Instruction Manual for XPR-5586
U.S. Patent #10,879,519
Please read these instructions
They include important safety information and operating instructions.
THE XPR-5586 IS APPROVED FOR USE
Bayco Products, Inc.
Ex ia FLASHLIGHT FOR USE IN HAZARDOUS LOCATIONS
UL listed for use with Bayco Li-ion Battery Pack 5586-4-BATT
E 467756
ID 4003544
INTRINSICALLY SAFE
SECURITE INTRINSEQUE
WARNINGS - INTRINSICALLY SAFE
y Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this
product in the hazardous environment. This task must ONLY be performed in an area known
to be non-hazardous.
y Warning: Lithium-ion batteries must be used and charged properly. Improper use can
result in serious injury, fi re, or death.
y Warning: Use only the included and approved 5586-4-BATT rechargeable battery pack
from Bayco Products.
y Warning: When exchanging the rechargeable battery pack, use only the approved 5586-4-
BATT rechargeable battery pack from Bayco Products.
y Warning: To prevent ignition of a hazardous atmosphere, the rechargeable battery pack
must only be exchanged in an area known to be non-hazardous.
y Warning: Do not expose the rechargeable battery pack to water or salt water, or allow the
battery pack to get wet.
y Warning: Do not store the rechargeable battery pack with metallic objects that may cause
a short circuit.
y Warning: Substitution of components components is not allowed and may impair intrinsic
safety.
SPECIAL INSTRUCTIONS FOR INTRINSIC SAFETY
For personal safety, always confi rm the rating of any known hazardous or potentially
hazardous location where the light is to be used.
INITIAL USE
Warning: To prevent ignition of a hazardous atmosphere, do not attempt to charge this
product in the hazardous environment. This task must ONLY be performed in an area
known to be non-hazardous.
CHARGER INPUT: 12 VDC Max
Fully charge the XPR-5586 before the fi rst use, or if the battery is new or has been unused
for several months. The maximum charge time required is approximately 6 hours.
DAILY USE
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, DO NOT ATTEMPT
TO CHARGE THIS PRODUCT IN THE HAZARDOUS ENVIRONMENT. THIS TASK MUST
ONLY BE PERFORMED IN AN AREA KNOWN TO BE NON-HAZARDOUS.
y Use only the supplied Nightstick charger, 5586-4-BATT rechargeable battery pack and AC
or DC adapter. For best performance, charge the 5586 when the fl ashlight beam starts to dim.
y Connect the AC power adapter to the charger. The LED indicator will not be illuminated
at this point.
y With the fl ashlight facing forward, slide the 5586 into the charger until the contacts snap
into place.
y The LED indicator changes to constant red indicating the 5586 is properly inserted into the
charger and is in fact charging. The LED indicator remains red until the battery is fully charged.
At full charge, the LED indicator turns green.
y The total time to full charge the 5586 varies depending on the remaining charge in the
battery pack.
y To confi rm a full charge, keep the 5586 in the charger and turn it on. The LED indicator
will change to red. Turn off the 5586. If the 5586 is fully charged, the LED indicator will turn
green. If not, it remains red until the charge is completed and the LED indicator turns green.
The 5586 will now be fully charged.
Bayco Products, Inc. • 640 South Sanden Blvd. • Wylie, TX 75098 • USA • 1-800-233-2155 • 1-469-326-9400 • www.nightstick.com
before using your Nightstick
XPR-5586
CLASS I DIV 1 GRPS A-D T4
CLASS II & III DIV1 GRPS E-G T135°C
CLASS I ZONE 0 GROUP IIC
-10ºC ≤ Tamb ≤ +40ºC
3.7V/Cell Li-ion
XPR-5586
REPLACING LITHIUM-ION RECHARGEABLE BATTERY
The product is designed to allow the end user to replace it if needed. To replace the
rechargeable battery pack, carefully follow the instructions listed below:
WARNING: WHEN EXCHANGING THE RECHARGEABLE BATTERY PACK, USE ONLY
THE APPROVED 5586-4-BATT RECHARGEABLE BATTERY PACK FROM BAYCO
PRODUCTS.
WARNING: TO PREVENT IGNITION OF A HAZARDOUS ATMOSPHERE, THE
RECHARGEABLE BATTERY PACK MUST ONLY BE EXCHANGED IN AN AREA KNOWN
TO BE NON-HAZARDOUS.
y Remove 8 screws on the base plate on the bottom of the light.
y Remove the base plate from the light.
y Remove the U-Clamp from chassis.
y Remove the battery pack electrical connector from the circuit board.
y Connect the new battery pack electrical connector to the circuit board.
y Replace U-Clamp and screws to chassis.
y Replace the base plate and screws on the light.
OPERATION
The XPR-5586 has ten lighting modes:
y High brightness fl ashlight
y Medium brightness fl ashlight
y Low brightness fl ashlight
y High brightness fl oodlight
y Medium brightness fl oodlight,
The XPR-5586 has two body switches providing access to all modes.
Constant-on Flashlight
Press the left switch forward for high-brightness fl ashlight. Press the switch forward again
to turn the light off.
Select Brightness Level
Press and hold the left switch forward. The fl ashlight will cycle from high to medium to low
mode and then back up again at a rate of approximately one mode per second. The light will
continue to cycle up and down through the various modes as long as the left switch is held
down. When the desired brightness level is reached, release the left switch and the light will
remain in that brightness mode. Press the left switch forward again to turn the light off.
Rear Facing Lights
Press the left switch backward to turn on the rear facing red lights. Press the the switch
backward again to turn the lights off. Press and hold the left switch backward to activate the
rear facing beacon lights.
Constant-on Floodlight
Press the right switch forward for high brightness fl oodlight. Press the switch forward again
to turn the light off.
Select Brightness Level
Press and hold the right switch forward. The fl oodlight will cycle from high to medium to
survival mode and then back up again at a rate of approximately one mode per second. The
light will continue to cycle through the modes as long as the right switch is held down. When
the desired brightness level is reached, release the left switch, and the light will remain in that
brightness mode. Press the right switch forward again to turn the light off.
Floodlight Beacon
Press the right switch backward for fl oodlight beacon. Press the switch backward again to
turn the fl oodlight beacon off.
Dual-Light
Dual-Light allows the user to turn on both the Flashlight (at any brightness level) and the
Floodlight (at any brightness level), at the same time. First select the appropriate brightness
level of the fl ashlight using the directions above. Next select the appropriate brightness level
of the fl oodlight using the directions above. Both the Flashlight and the Floodlight are now
running. Press and release both the left and right switches forward to turn the lights off.
INS-XPR-5586-DL-21
y Survival mode
y Blinking fl oodlight
y Dual-light
y Constant-on rear green light
y Blinking rear facing light
11-10-2021