Transmitter Panel Description - Kindermann 4K60 Inbetriebnahme- Und Bedienungsanleitung

4. Transmitter panel description

OUT
SIG
1
No. Name
CAT OUT
1
2
IR IN
3
IR OUT
RS232
4
5 DISPLAY
6
SOURCE
EDID
7
8
DC 12V
12
IR
IR IN OUT Tx Rx
2 3 4
Description
Connects to the CAT IN port of receiver by CAT cable. It
supports 12V PoC, the transmitter can be powered from
the receiver. The green LED illuminates when power is
applied. The LED illuminates orange when a HDMI signal is
transmitted.
Connect IR receiver
Connect IR emitter
Connects to RS232 interface (e. g. media control system) to
pass-through commands
Connect local HDMI device
Connect HDMI source device
3-pin DIP switch for EDID setting.
• MERGE: If there are two displays connected to HDMI-
CAT Extender Set 4K60, The EDIDs will be merged
to ensure that the video signal can be shown on both
displays.
• BYPASS: The source device gets the EDID from the
display connected to receiver's HDMI output.
• COPY Tx: The source device gets the EDID from the
display connected to transmitter's HDMI loop output
DC connector for power supply
BYPASS
MERGE
SOURCE
DISPLAY
5 6
COPY Tx
DC 12V
7 8
.