CHESTER GT67006 Bedienungsanleitung Seite 12

• Before cleaning the pump or performing maintenance, the following safety notes must be
observed:
• When opening covers or removing casing parts you may expose live parts.
• Therefore, disconnect the device from all voltage sources before performing maintenance
work or repairs. Capacitors inside the device may still carry voltage even though they have
been disconnected from all voltage sources.
• Repairs may only be carried out by qualified personnel who are familiar with the hazards
involved and the relevant regulations.
• In industrial facilities the regulations for the prevention of accidents as laid down by the
professional trade association for electrical equipment and devices need to be observed!
• When in doubt about how to connect it correctly or should any questions arise that are
not answered in these operating instructions, as to the operation, the safety or the
connection of the device, contact our Technical Advisory Service or another expert.
• Do not leave packaging material unattended. It could become dangerous playing material
for children.
Main component
1. Body of the pump
2. Carrying handle
3. Suction inlet with particle filter
4. Pump nozzle pipe : 1'', G1, 1-
5. Floating switch
Positionning
This submersible pump is intended for use as a cellar pump to protect against flooding and for
removal of water in domestic situations, e.g. in gardens, greenhouses, etc. There must be
sufficient space around the pump for the float to move freely.
Place the pump in the required location and then plug it in.
The pump must be on a level surface, so that there is no risk of it tipping over while in
operation.
The pump can be fully or partially submerged in water. Tie a piece of rope around the carrying
handle, if necessary, before submerging in deep water, and also check that the cord is long
enough for the water depth.
The pump must not be left suspended by its cord or hose.
1/2 ''
www.chestergarden.be
GB
12