Cleaning And Maintenance - Rebel Rb-6303 Bedienungsanleitung

Product description
1. USB type C port
2. Induction charger
3. Standby button
4. Up navigation button
5. Function button
6. Down navigation button
2
3 4
Operation
1. Connect the device to a charger with USB cable (not included in
set).
2. To set clock:
• Press and hold function button.
• Chose time mode (12 or 24 hour) with navigation buttons.
Press function button to confirm selection and go to the
clock settings.
• To set time, use navigation button; function button confirms
selection and closes settings.
3. Press and hold up navigation button to change temperature unit.
EN
1
M
5 6
8
4. To set the alarm, press the function button twice and then press
and hold the function button. Setting the alarm should be done
in the same way as setting the time using the navigation
buttons.. After confirming the time with the function button, the
alarm will be turned on. To deactivate it, press the function
button until the message ON A1 is displayed and press the down
navigation button. You can enable up to 3 alarms.
5. To adjust the brightness of the display, press the navigation
button down until the desired option is selected. Confirm with
function button.
• mode 0 adjusts the brightness according to the time of day
• modes 1 - 4 indicate the brightness levels of the display
• mode 5 turns the display off after 5 seconds of inactivity
6. To change display settings, press the up navigation button until
the desired option is selected. Confirm with function button.
• DP-1 - the time is displayed for 10 seconds, followed by the
date for 2 seconds
• DP-2 - only time is displayed
• DP-3 – keep the current display

CLEANING AND MAINTENANCE

To clean the casing, unplug the unit and wipe it with a soft, damp
cloth (do not use abrasive polishes nor other chemicals)
9
EN