Unpacking; Intended Use; Set-Up And Commissioning - IKA R 472 Betriebsanleitung

• The handwheel bolt on the stand can come loose due to vibration,
which would lead to the unit moving down. So, check the tightness
of the handwheel bolt regularly when using the unit, and retighten
it if necessary.
• Raise or lower the stand (after slackening the handwheel bolt) by
applying the manual force as close as possible to the stand pillar.
The further the force is applied from the pillar, the more force you
need to apply, plus there is an increased risk of the equipment top-
pling over.

Unpacking:

- Please unpack the device carefully.
- In the case of any damage a detailed report must be sent immedi-
ately (post, rail or forwarder).
Use:
The R 472 Floor stand / R 474 Telescopic stand is used solely for
mounting RW 47 digital agitator units.
WARNING
R 472 Floor stand: the castors must be locked when the device is in use.
The T 653 Telescopic stand is used solely for mounting T 65 basic
/ digital ULTRA-TURRAX
®
Setting up the stand (R 472 Floor stand):
8
dispersion units.

Set-up and commissioning

Place RW 47 digital overhead stirrer on the arm of the stand. Fasten the
overhead stirrer to the stand from below with hexagonal socket screws sup-
plied. The help of an assistant is needed for screwing on the overhead stirrer.
The cable clips included in the delivery package are required for fixing the
power cable of the unit.
Check that the stirrer is held in position firmly prior to each use and also at
regular intervals. The position of the stirrer must only be adjusted when the
equipment is stationary and the power supply is disconnected.
NOTICE
• Secure the vessel against spinning round, by using a clamp, for ex-
ample.
• Observe the operating instructions of the T 65 basic / digital UL-
TRA-TURRAX
• Check the appliance and accessories beforehand for damage each
time you use them. Do not use damaged components.
• Protect the appliance and accessories from bumps and impacts.
Unpacking
Delivery scope:
Telescopic stand
- R 472 Floor stand or R 474 Telescopic stand or T 653 Tele-
scopic stand according to order
- Operating instructions.
For technical reasons associated with shipping, the telescopic stand is
supplied stripped down, as pre-assembled modules.

Intended use

The safety of you cannot be guaranteed:
- If the device is operated with accessories that are not supplied or
recommended by IKA.
- If the device is operated improperly or in contrary to the IKA spec-
ifications.
dispersing unit or the RW 47 digital stirring unit!
®