heicko G2 Bedienungsanleitung Seite 3

User manual
User manual
Channels
Channel selection
button - (K-)
HD15B - 15-channel emitter, black
Technical Data
• Battery 3 V, CR2450
• Frequency 433,92 MHz
• Ambient temperature: -10°C bis 50°C
• If the transmitter range or signal strength decreases, a battery replacement is required.
• Moisture, excessive temperature, dust and force harms the device and can destroy it.
Notes
Attention!
Please carefully read the operating instructions of the emitter as well as the instructions of the tubular motor with built-in receiver / external receiver before commissioning and
observe ist instructions.
Important notes!
The emitters described are exclusively intended for the transmission of radio signals to our tubular motors and external receivers with radio code G2. Information on which
emiters have radio code G2 is available at www.heicko.de or www.heicko-bewegt.de.
The scope of this manual is limited to the description of the emitter as a control element. The description of the programming ("teaching", etc.) with respect to the above
mentioned tubular motors with built-in receiver as well as the external receivers is given in the instructions for the tubular motors with built-in receiverse and external receivers.
15-channel emitter HD15B
The button assignment for the general functions is shown in the figure at the to of this page.
The desired channel is selected with the channel selection buttons.
If channel 15 is active, pressing the right channel selection button again activates the group function. In the group function, all channels can be controlled simultaneously and
operated together by pressing the function buttons Up, Stop and Down - in the group function channel "0" is displayed.
Hide channels
• In this model channels that are not used can be hidden.
C
+
Press channel During pressing
the display
selection buttons
simultaneously shows „C"...
for 3 seconds angezeigt...
Display „Up"
15
Display „Down"
Up
Stop
Down
Channel selection
button + (K+)
15
... and as soon as
the 3 seconds
passed, it
shows „15"
Radio code G2
Back:
Battery compartment (without cover)
and function buttons.
Setup button P2
P2
• Transmission power: 10 mW
• Transmitter range: 100 m (outdoors)
35 m, through max. 2 walls
or
Press stop
for 3 sec.
Select the number
of channels that
are supposed to stay active
E.g. 1, 2, 3, 4, 5 ...
-1-
Setup button P2
P2
o
During pressing
the display
shows „o"...
QR-Code for
User manual
5
... and as soon as
the 3 seconds
passed, it shows
the number of
chosen channels