meilan C3 Bedienungsanleitung

English
MEILAN C3 Bike Speed/Cadence Sensor
Installment of C3(Speed/Cadence Sensor)
1.When you use our product in first me, please open the ba ery cover of
speed/cadence sensor with a coin in a rota on way. Take out the ba ery and peel
off the insula ng film,
assuring that the
ba ery and device
can work normally.
2.Fix speed/cadence sensor in the very place of the photo: first use two nylon belts
to ghten( Image A-1); then use one rubber belt to fix again(
A-1
3.Peel off the 3M on the back of the cadence magnet and S ck it to the inside part
of the pedal connec ng arm. Use 2 nylon belts to fix it and cut off the longer part.
4.Install the wheel magnet into the spoke and ghten it in a rota ng way, assuring
the magnet not to slide in high speed.
Then ghten the
ba ery cover.
Image A-2).
A-2
*Note on Installment:

I.Core center of cadence and Wheel magnet
must be aligned with very part of the sensor;
There is one small triangle in the counterpart
of cadence magnet and speed magnet. If it is
not installed right way, it is probably the data
gets down to 0 when it exceeds from 40-60
always.
II.The distance between magnet and the senor can not exceed 2CM.If exceeded, the
device probably can't get the rota ng signal. Can use screw driver to loose the screws
and adjust the distance between sensor and magnet. There are some race bike, road
bikes and indoor training device with special design, which are not fit for this installa on;
Please take it into considera on before purchase.
III. The sensor and the magnet must be assured with strong and steady
installment so that there is no drop or devia on
Seller: MEILAN(HONGKONG) CO., LIMITED
Manufacturer base: 5/F, B16 Building, Hengfeng Industrial Town, Hezhou, Hangcheng Street, Bao'an
District, Shenzhen City, P.R.C(CHN)
Tel: +86 755 23159119
Speed Sensor
Cadence Sensor
Induc on
Induc on