DriveCliq STANDARD
ASSEMBLY INSTRUCTIONS
MONTAGEANLEITUNG
6FX2003-0DC20
A5E01080558
Stand: 15.04.2021
Insert the prepared cable into the plug using the Y-Con Tool-30 until it stops
04
Vorbereitetes Kabel mit Hilfe des Y-Con Tool-30 bis zum Anschlag in den Plug einführen
Y-Con Tool-30
Put the assembled RJ45 into cover 20 as shown and compress
06
Assemblierten RJ45, wie abgebildet, in Cover 20 einlegen und zusammendrücken
!
Watch out! The tab must
necessarily point upwards
Tab/Hebel
Achtung! Das Hebel muss
unbedingt nach oben zeigen
Y-Con Tool-30, Y-Con Tool-11: YAMAICHI ELECTRONICS|www.yamaichi.de
Y-Con Tool-30, Y-Con Tool-11: YAMAICHI ELECTRONICS|www.yamaichi.de
DriveCliq STANDARD
DriveCliq STANDARD
Strip the cable to the appropriate length
01
Kabel auf passende Länge abisolieren
Y + ~10mm
X
∅
Y
03
X
∅
Recommended Pre-Assembly
Stripping lenght
Abisolierlänge
Empfohlene Vorbereitung
Cable diameter
A±1.0mm
X±1.0mm
Y±1.0mm
Kabeldurchmesser
∅6.1 - 6.6mm
X=15.0mm
Y=30.0mm
A=11.5mm
∅6.7 - 7.1mm
X=18.5mm
Y=33.0mm
A=15.0mm
!
Check dimension A before crimping!
Maß A vor dem Crimpen prüfen!
A
Thread single wires into the insert as shown
Connector A/Stecker A
02
Einzellitzen, wie abgebildet, in Insert einfädeln
A
1
Connect the plug with the crimping tool as shown
05
Plug mittels Crimpzange, wie abgebildet, mit dem Kabel verbinden
Y-Con Tool-11
1
A tool may help to close parts securely
Eine Parallelzange erleichtert das Einrasten
Touchpoint for tool
Ansatzpunkt für Parallelzange
Connector B/Stecker B
2
6
B
A
2
6
B
3
3
1
2
4
6
READY TO
PLUG
3
5