Maintenance Information - Ebotics Mega Maker Kit Robotics And Programming Bedienungsanleitung

MAINTENANCE INFORMATION

• Do not turn off the computer or disconnect the USB cable when a program is
being installed on the board.
• Regularly clean the board and the cable with a dry cloth. They must be dry
when you clean them.
• Keep the board connectors and the cable free from dust, lint, etc. To prevent
improper connections.
• Avoid breaking the cables. Do not put objects over them.
• Do not pull the cable to disconnect it from the computer or the board.
• Keep the cable extended when it is being used.
• Avoid dropping or hitting the board. It might be damaged.
• When not using the product, store it in a case to protect it from dust and dirt.
SECURITY INFORMATION
• Confirm the board is always working in the recommended voltage range (7-
12V). Never work out of the voltage limit range (6-20V)
• Check your circuit before connecting it to the board, at least once. Confirm
that there are short-circuits.
• Do not throw the board and/or the cables into fire and keep them away from
heat sources.
• Do not connect the cables to a power outlet.
• Do not wet the board. Keep it always in a dry place, away from humidity.
• Do not use the product if you perceive any visible defects.
• We recommend you to use the supplied cables with the product.
• Disconnect the board from the computer if you are not going to use it.
• Keep it away from children. Contains small pieces which may be a choking
hazard.
• Children must use this product under adult supervision.
• Do not build circuits that can be dangerous for you (physically / health) or that
can be dangerous for other people.
• Do not dismount or modify the board. These actions will invalidate the
Warranty.
22