Safety Warnings - IGNIA LIGHT onled Monocolor Handbuch Für Die Elektrische Zusammenhang

ENGLISH
IMPORTANT: The instruction manual you are holding includes essential information on the safety measures
to be implemented for installation and start-up. Therefore, the installer as well as the user must read the ins-
tructions before beginning installation and start-up.
Keep this manual for future reference.
To achieve optimum performance of the OnLED Projector, follow the instructions provided below:
1. ELECTRICAL CONNECTION (see figure 1):
The spotlights are supplied with a 2x1.5mm 2 Cu H07RNF cable. You should make sure that the voltage received by the
projector is never more than 12V, by a safety transformer. The Transformer must be dimensioned to supply the corres-
ponding VA to each LED lamp which is connected (see table on back page).

2. SAFETY WARNINGS:

• If the cable or wiring of this luminaire becomes damaged, it may only be replaced by the manufacturer or one
of its service engineers, or a person with a similar qualification, in order to avoid any accidents.
• The light source of this luminaire is not replaceable; when the light source reaches the end of its service life
the whole of the luminaire must be replaced.
• The luminaire should be fitted in such a way that it is not possible to stare at it from closer than 0.75m (only in
the case of models with white light).
• The persons who are in charge of assembly should have the required qualifications for this type of work.
• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed. WIRING IN BUILDINGS. SPECIAL WIRING. SWIM-
MING POOLS.
• Any operation related to the maintenance or replacement of parts should be performed with the floodlamp
disconnected from the electric power system.
• The luminaire is designed TO BE USED ONLY SUBMERGED IN WATER and TO OPERATE ONLY WITH A SAFETY
TRANSFORMER.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric
components which have been inserted or handled at locations other than its own premises.
2