Werbung
Verfügbare Sprachen
Verfügbare Sprachen
Instrumentenkanal (3) für Keyboard (alternativ CD Player, MP3)
D
E
21. Volume Regler
verändert die Lautstärke des angeschlossenen Geräts
U
22. - 24. EQ Regler
Regler für die Klangfarbe des Tons (Equalizer),
T
regelt die Höhenanteile (Treble) / Mitten (Mid) / Bass
S
25. Input Audio
Audio-Eingangssignal Keyboard, CD, MP3, etc. Chinch L/R
C
H
38. Volume Regler
regelt die Gesamtlautstärke des Instrumentenkanals (3)
39. Reverb Regler (Hall)
regelt den Anteil des Reverb (Hall-Effekts)
Auf der Rückseite befinden sich die Bedienelemente und Eingänge
für die Kanäle Mikrofon (1) und Mikrofon (2) sowie Anschlüsse für
Fußschalter, Kopfhörer, etc.
26. Sicherung (Fuse)
Feingerätesicherung 230V AC / T1.0 A L
27. Netzkabel
Anschluss für 110/230V AC 50/60Hz
28. Fußschalter / Effekt
schaltet den internen Hall (Reverb) An/Aus
29. Fußschalter / Kanal
wechselt im Gitarrenkanal zwischen Distortion und Clean
30. Kopfhörerausgang
Ausgang für Kopfhörer 6.35mm Klinke
31. Line Out
Ausgang Audiosignal zum Anschluss an einen externen
Verstärker oder Mischpult, Klinke 6.35mm
Kanäle Mikrofon (1) oben und Mikrofon (2) unten
32. - 34. EQ Regler
Regler für die Klangfarbe des Tons (Equalizer),
regelt die Höhenanteile (Treble) / Mitten (Mid) / Bass
35. Effekt (Reverb)
Regelt den Hall-Anteil (Reverb) auf dem Mikrofonkanal
36. Volume
regelt die Lautstärke des Mikrofonkanals
37. Input MIC1/MIC2
XLR Eingang für dynamisches Gesangsmikrofon MIC1/MIC2
Precautions
Please read carefully before proceeding
Always follow the basic precautions listed below to avoid the possibility of serious injury or
even death from electrical shock, short-circuiting, damages, fire or other hazards. These
precautions include, but are not limited to, the following:
Power supply / power cord (devices with power cords/power supplies):
• Only use the voltage specified as correct for the device. The required voltage is printed on the type plate of the device.
Check the power cable from time to time regarding dirt, damage or other influence.
• Use only the included power cord / power supply or adaptor. Do not place the power chord near heat sources such as
heaters or radiators, and do not excessively bend or otherwise damage the cord, place heavy objects on it, or place it in
a position where anyone could walk on, trip over, or roll anything over it.
• Remove the electric plug from the outlet when the device is not to be used for extended periods of time, or during
electrical storms. When removing the electric plug from the device or an outlet, always hold the plug itself and not
the cord. Pulling by the cord can damage it.
• To avoid generating unwanted noise, make sure there is adequate distance (50 cm or more) between the AC power
adaptor and the device. Do not cover or wrap the AC power adaptor with a cloth or blanket.
Location:
• When setting up the device, make sure that the AC outlet you are using is easily accessible. If some trouble or
malfunction occurs, immediately turn off the power switch and disconnect the plug from the outlet. Even when the power
switch is turned off, electricity is still flowing to the product all the minimum level. When you are not using the product
for a long time, make sure to unplug the power cord from the wall AC outlet.
• Inadequate ventilation can result in overheating, possibly causing damage to the device(s), or even fire.
• Do not expose the device to excessive dust or vibrations, or extreme cold or heat (such as in direct sunlight, near a
heater, or in a car during the day) to prevent the possibility of panel disfiguration or damage to the internal components.
• Do not place the device in an unstable position where it might accidentally fall over.
• Do not block the vents. This device has ventilation holes at the bottom/rear to prevent the internal temperature
from becoming too high. In particular, do not place the device on its side or upside down. Inadequate ventilation
can result in overheating, possibly causing damage to the device(s), or even fire.
• Do not use the device in the vicinity of a TV, radio, stereo equipment, mobile phone, or other electric devices.
Doing so may result in noise, both in the device itself and in the TV or radio next to it.
Connections and handling:
• Before connecting the device to other devices, turn off the power for all devices. Before turning the power on or off
for all devices, set all volume levels to minimum. • Do not use the device or headphones for a long period of time at
a high or uncomfortable volume level, since this can cause permanent hearing loss. If you experience any hearing loss
or ringing in the ears, consult a physician.
• Do not rest your weight on the device or place heavy objects on it, and avoid use excessive force on the buttons,
switches or connectors
Do not open:
• Do not open the device or attempt to disassemble the internal parts or modify them in any way. The device contains no
user-serviceable parts. If it should appear to be malfunctioning, discontinue use immediately and have it inspected by
qualified service personnel.
Water warning:
• Do not expose the instrument to rain, use it near water or in damp or wet conditions on it containing liquids which might
spill into any openings. Never insert or remove an electric plug with wet hands.
If you notice any abnormality:
• If the power cord or plug becomes frayed or damaged, or if there is a sudden loss of sound during use of the device, or if
any unusual smells or smoke should appear to be caused by it, immediately turn off the power switch, disconnect the
electric plug from the outlet, and have the device inspected by qualified service personnel.
Noise:
• Listening to loud music for longer periods may lead to hearing damage
E
N
G
L
I
S
H
Werbung
