Connection And Start-Up - Migatronic Push Pull FKS 400 torch Betriebsanleitung

Connection and start-up

Warning
Read warning notice and
instruction manual carefully prior
to initial operation and save the
information for later use.
Recommended cable dimensions
c
c
Welding current DC
200 A 35 mm²
300 A 50 mm²
400 A 95 mm² / 2x50 mm²
500 A 2x70 mm²
Welding process
MIG - IAC and pulse 10 m
MIG - non pulse 30 m
b
a
PULSE
35 mm²
70 mm²
95 mm² / 2x50 mm²
2x70 mm²
Distance to Total cable length
work piece in welding circuit
(a+b) (a+b+c)
20 m
60 m
WARNING
When you activate the torch trigger, there is
voltage applied to the welding wire.
The Push Pull FKS 400 is a welding torch with integrated drive
unit for manual welding using soft welding wires and with
long welding hoses.
The Push Pull torch is supplied ready for use with water-cooled
SIGMA SELECT and AUTOMIG 300 PULSE.
Connecting PP FKS 400
1. Connect the 17-pin plug [1] to the power source
2. Connect the welding torch [2] to the power source
3. Connect the two connectors [3] (blue/red) to the water
quick releases on the power source
The machine will automatically register a connected
PP FKS 400.
10
Important!
In order to avoid
destruction of plugs and
cables, good electric
contact is required when
connecting earth cable
and welding hose to the
machine.
3
1
2