Recommendations For Use - J BIMBI Slim Bedienungsanleitung

Slim
Digital scale
Thank you for choosing a J BIMBI® product. This Slim digital scale is a useful and reliable tool for
monitoring the growth of children right from the first days of life because it detects even the slightest
changes in weight. The ergonomic and ultra-slim design makes it practical and easy to handle, while
the automatic weighing lock function and the large backlit LCD display make it easy to read and detect
the weight.
Read the instructions carefully before using this device.

RECOMMENDATIONS FOR USE

Place the scale on a flat, stable surface; uneven or soft surfaces (e.g. rugs, beds, sofas) may cause
inaccurate weight measurements.
Make sure the surface of the scale is clean and dry before measuring your baby's weight.
HOW TO USE THE DEVICE
How to install the batteries
This scale operates with 4 standard AA batteries (included). Turn the scale upside down and install the
batteries in the battery compartment making sure to respect the polarity as shown. Close the cover and
place the scale on a flat, stable and solid surface.
When the batteries are low the display shows «LO» (1), open the battery compartment and replace the
batteries. Remove the batteries if you plan to leave the scale unused for a prolonged period of time.
kg/lb weight unit setting button
Located to the left of the display, this button allows you to choose the unit of measure when weighing:
kilograms (kg) or pounds (lb). Select the desired weight unit when the scale is on and «0.00» is displayed
(2) (otherwise the unit of measure cannot be changed).
How to use the scale
1. To obtain accurate measurements place the scale on a flat, stable surface. Uneven or soft surfaces
can cause inaccurate weight measurements.
2. Press the "ON/OFF - Tare" button to power on the scale. The display will show «Hello» (3) and after a
few seconds «0.00» (2).
3. Press the "Weight unit" button to select the desired weight unit (kg or lb).
4. Gently place the baby on the scale, paying special attention to the head.
5. When the weight is detected, the value flashes 3 times on the display and then it remains displayed.
6. After measurement, press and hold the "ON/OFF - Tare" button to power off the scale. If there is no
weight change, the display will continue to show the value of the last measurement for one minute
and then it will automatically power off.
Tare function
This function allows to weigh and exclude from the measurement the weight of any mat or towel placed
on the scale to weigh a naked baby.
1. Press the "ON/OFF - Tare" button to power on the scale. The display will show «Hello» (3) and after a
few seconds «0.00» (2).
2. Place the mat or towel on the scale, the weight will flash 3 times on the display and then it will
remain displayed.
3. Press the "ON/OFF - Tare" button, the display will show «Tare» (4) and then «0.00» (2).
4. Measure the weight according to point 3 in the "How to use the scale" section.
EN
5