Hardware Installation; Software-Installation - Konig Electronic CMP-WEBCAM3D10 Anleitung

ENGLISH

Hardware Installation:

Connect the webcam to your PC using the USB 2.0 port. Place the webcam on your desk or monitor.
The best distance is about 1 m/3 ft. After connecting the webcam to your PC, you will see a "Found New
Hardware" message as in the picture below. Please wait a few seconds until the hardware installation is
finished.
Software installation:
After placing the CD into your CD-rom drive and closing it, wait a few seconds and a screen will appear as in
the image below.
Click the "3D Web Camera Setup" button to install the 3D software and follow these steps:
Double click the icon that will appear on your desktop. (see picture below)
You will see a pop-up in the notification area which indicates that the software is being installed.
After a few seconds you will see this screen:
2