Inhaltsverzeichnis
Werbung
12
1176-KT
1176-KT Controls
(1)
(2)
(9)
(3)
(4) (5)
(6)
(7)
(8)
(10)
(11) (12)
Step 2: Controls
(1) Adjust the INPUT knob to simultaneously set
the signal level entering the unit and also set
the compressor threshold. Turning the knob
clockwise will result in more compression.
(2) The OUTPUT knob sets the overall level sent
from the unit.
(3) Use the ATTACK knob to adjust the amount
of time it takes for the compressor
to respond to audio that exceeds the
threshold. The response time is slow when
set fully counterclockwise and faster as it is
turned clockwise.
(4) The RELEASE knob adjusts how long the
compressor remains engaged after the
incoming audio falls below the threshold.
The response time is slow when set
fully counterclockwise and faster as it is
turned clockwise.
(5) The RATIO buttons determine the amount
of gain reduction. The lowest setting of 4:1
results in fairly mild compression, while 8:1
yields heavier compression. The 12:1 and
20:1 settings act as a limiter instead of a
compressor. Higher settings also increase
the threshold automatically. An extreme
eff ect can be achieved by pressing all 4 RATIO
buttons in simultaneously.
(6) The VU METER displays either the amount
of gain reduction or the output level,
depending on which operation is selected.
(7) The METER BUTTONS select whether the
VU meter displays the amount of gain
reduction (GR) or displays the output level.
A meter reading of 0 corresponds to an output
level of +4, +6 or +8 dBm, depending which
button is engaged.
(8) The POWER switch turns the unit on and off .
(9) OUTPUTS are available as balanced ¼ " and
XLR connectors.
(10)
INPUTS are available as balanced ¼ " and
locking XLR connectors.
(11)
Engage the PAD switch to reduce the input
sensitivity by 20 dB for use with hot signals.
(12)
The small meter adjustment pot allows
the meter to be calibrated. See the
'Getting Started' section for details.
Quick Start Guide
13
Werbung
Inhaltsverzeichnis
