Werbung
Assembly Preparation
Owner's Manual
Please check local building codes regarding footings, location and other requirements before beginning
construction.
Assembly instructions:
Reviewing all instructions and the appropriate information before you begin, make sure following the step
sequence carefully for successful results.
Flooring base:
A good location for the storage building is a square and level area with good drainage. The base is not
included in the kit which you may need to purchase separately or may construct a foundation and anchoring
system of your own.
A strong plastic sheet (thickness: at least 150μm) should be placed under the foundation to assist in reducing
rising dampness from the soil, thus reducing condensation build up in the shed. Your storage building must
be anchored to prevent wind damage. Once secured, it is highly recommended applying silicone along the
inside of the base rail to minimize condensation.
Parts and Parts List:
Before you start, separate and identify all the parts and hardware to be sure that you have all the necessary
parts for your building (refer to the Parts List Page).
If you find that a part is missing, please notify the seller within one week after receiving the product. Do not
attempt to assemble the building if parts are missing because any building left partially assembled may be
seriously damaged by light winds.
Kindly note the screws and washers' quantity is more than required, the left ones are for extra using.
Tools you need:
(Please tear off the safety protection layer before the assembly, keep the part number label if needed)
Safety must be put in the No. 1 position:
1. Select a dry and calm day for your assembly. Team works (Two or more people) are required during the
assembly. It is also recommended to finish the assembly in a day to avoid damage to the product or missing
of some small parts.
2. Wear safety gloves, eye protection and long sleeves during the assembly to prevent injury.
Pay attention to the sharp edge of some parts.
3. Children and pets are not allowed to enter the construction site.
4. Never concentrate your total weight on the roof of the building.
When using a step ladder make sure that it is safe.
Care & Maintenance:
1. Keep the shed clean with soft cloth, use water if necessary.
2. Keep the door tracks clear of dirt and other items that prevent them from sliding easily.
3. Clear heavy snow on the roof , heavy snow may make the roof unstable.
4. The shed is not made for living but storing stuff.
5. Please add some oil on the top and bottom door sliding channel to make door slides smoothly.
Werbung
