Flightline LAVOCHKIN LA-7 FLW202 Bedienungsanleitung Seite 6

Assembly
Install the elevator/rudder pushrods
D
1.lnsert one side of the elevator push rod A ,through the
plastic tube B, to the servo arm C.
2. Snap the clevis of elevator pushrod to the rudder horn D.
1.Slide the end of the rudder pushrod A ,through plastic tube B, to the servo arm C.
2.Snap the clevis of the rudder push rod onto the landing gear strut horn D.
NOTE:Use the rubber rings to lock the clevis shut.
/
Steering push rod size
•
I
Pushrod diameter: 0 1.2mm
(17-7/16") 1
..- 450mm -------.
Rudder pushrod size
�
Pushrod diameter: 0 1.2mm
�
l.----aamm(3-2/5"}
Elevator push rod size
I
•
Pushrod diameter: 0 1.2mm
1
+----490mm-------.
(19-1/3")
Lavachkin La-7
lte,n Na.: FLWii!Dii!
All manuals and user guides at all-guides.com
B
�----� --
Steering pushrod mounting hole
Rudder pushrod mounting hole
Elevator push rod mounting hole
;q-
2
3�
NOTE:
Use the rubber rings to lock the clevis shut.
D
&
Note: when connecting the rudder push rod,
ensure the tail wheel is centered. Then attach the
rudder push rod to the tailwheel control horn, and
adjust the plastic clevis so that the rudder is centered
when the clevis is attached to the rudder control horn.
1. Glue the rudder control horn to the rudder
(see diagram)
2. Use the rudder p ush rod to connect the tail
gear control horn to the rudder control horn.
.....
IE3f:m
t
Pliqht(f!J!!.
EN
I ,
(
l�