Getting Started; Charging The Battery; Turn On/Off - Ricatech RATAB7-01 Bedienungsanleitung

Getting Started

CHARGING THE BATTERY

1. Plug one end of the adaptor into a power outlet, the other end into the device. The LED
charging indicator turns red, indicating that the device is currently being charged.
2. During charging, the battery icon animation will appear on the screen. When the device is fully
charged, the battery animation icon will stop and turn green.
Note: If the device is completely out of power, please connect it to a power outlet. And the screen will
prompt " the power is too low, charging now." You must charge the device for few minutes before the
device can be operated.
Maximizing Battery Life
1. The device uses internal Lithium-ion polymer battery. and must be charged with the supplied adap-
tor.
2. It is recommended to fully charge your b attery for 8 hours first two times. After that, the device can
be fully charged within 4 hours.
3. It is recommended to fully charge the device at least once a month to avoid permanent damage to
the battery.

TURN ON/OFF

To turn on the device, hold the power( ) button for three seconds.
To shutdown the device, hold the power( ) button for three seconds and select "OFF" then
"OK" on screen.
Note: 1. The device will be turned off automatically when it is low on battery.
2. If the device is not properly shutdown, the device will attempt to scan and repair
memory storage after restarted. This may cause the device take longer time to boot up.
3. By pressing power( )button it will put the device into power saving standby mode. To turn it back
on, simply press the power( ) button again.