Dmx-512 Connection - Beamz professional LED IntiBar300 Barrel 30W LED DMX Gebrauchsanleitung

DISPLAY
Note: 1. To the function mode you need, press ENTER to confirm, press MODE about two seconds to quit.
2. The equipment can accept DMX signal whenever Auto or sound active mode, DMX is preferential.
Display
Addr
SLnd
Shnd
SPLC
SoUn
SEnS
bLnd
Led
dISP
PAn
tESt
hour
uer
rSEt

DMX-512 CONNECTION

If you are using a standard DMX controller, you can connect the DMX output of the controller directly to the DMX
input of the first unit in a DMX chain. If you wish to connect a DMX controller with other XLR outputs you will need
to use adapter cables.
Connect the DMX output of the first unit in a DMX chain with the DMX
input of the next unit in the chain. Always connect the output of one unit
with the input of the next unit until all units are connected. If you use a
controller with 5 pin DMX connection you will need to use a 5 pin to 3 pin
adapter.
Caution at the unit, the DMX cable has to be terminated. Solder a 120 Ohm resistor between signal (-)
and signal (+) into a 3-pin XLR connector and plug this into the DMX output of the last unit in the chain.
8
When choose a function, press MENU button, select menu options you want.
Press ENTER button to the selected function, the display will be flash, then press
UP/DOWN button to select the required function, press ENTER button, or wait for
10 seconds or press MENU button.
Mode
DMX address setting
Slave mode
Show mode
Color function
Sound mode
Sound sensitivity
Scanning
LED mode
Display inversion
Pan inversion
Test mode
Using time of light
Reset
Function
A001-A512
Master
Slave 1
Slave 2
Show 0
Show1 ~ show6
Full color
Half color
Sound on/off
Sound sensitivity 0-100
Normal operational scanning
Stop working
ON-OFF
Led display positive
X-as position
X-as reverse position
Self test
Fixture hours,0 ~ 9999
Software version
reset