Oursson FZ0805 Bedienungsanleitung Seite 12

PLACING, Рiс. В
• Place the device in a good ventilated space.
• The device must be placed on a flat horizontal surface.
Be sure to leave a gap of 5-10 cm between each side of
the device and wall or furniture, and 30 cm of free space
on top of the device, Pic. B-1.
• For placing, choose a space that isn't exposed to sun-
light, high temperature and moisture.
• Before placing, remove the lower panel.
• After placing, the product must be leveled using the ad-
justable feet, to lift the product turn the feet clockwise,
Pic. B-2.
• Insecure position of the device may lead to noise and
vibration. The noise occurs when the device is placed
on unsteady or uneven floor.
• Make sure that the adjustable feet are in contact with
the floor. It is recommended to place the device a little
bent over backwards to ensure a tight closing of doors.
PRODUCT SET
1 Container for the freezer..........................................3 pcs.
Instructions manual.......................................................1 pcs.
ELEMENTS OF DESIGN, Рiс. С
Temperature regulator
1
The freezer containers
2
UTILIZATION, Рiс. D
Recommendations on first use
If you are using the device for the first time, remove all un-
necessary things: packaging materials, tapes, etc. carefully
wash all the inner surfaces (where the food is stored) with
water with a little acetic acid. New device must be indoors
for 2-4 hours before tuned on. Follow the instructions
manual and plug in the device in a grounded socket. It is
necessary to wait few hours before loading food into the
device, for it to reach working temperature. Please, fill the
device with food gradually, so that compressor does not
break.
Turning on the device, Рiс. D-1
Before filling food, turn on the device for 2-2,5 hours for it to
reach working temperature. Set the temperature regulator
on the middle position «7».
Placing the products, Рiс. D-2
• Each drawer should contain no more than 25 kg of food.
• Products must be tightly packed.
• For the food to rapidly freeze, put in each package no
more than:
• Fruit, vegetables up to 1 kg
• Meat, up to 2.5 kg.
• Pack the food in portions in freezer bags, containers
from plastic, metal or aluminum.
• Hot food must be cooled to a room temperature, before
placing into the device, otherwise the power consump-
tion will be higher.
• To lower the power consumption it is recommended to
open the device less often.
12
Setting the temperature, Рiс. D-1
The temperature in the device is regulated by a
switch from position «1» (minimum freezing) to posi-
tion «7» (maximum freezing). To turn off the device,
set the switch into «0» position. It is recommended to
select the middle position «4», the average tempera-
ture inside the device will be around -18°C. For a fast
freezing of the products set the switch into the «7» po-
sition, the average temperature inside the device will
be around -24°С.
The room temperature in which is the device,
number of products, time and frequency of
opening the door of the device has an effect
on the cooling temperature and power con-
sumption.
Economic power consumption
• Do not block the vents.
• Do not place the device near the oven, heating sys-
tem and electric heaters and avoid direct sunlight. Do
not leave the door of the device or freezer open for
too long.
• The power consumption depends on the selected cool-
ing temperature.
• In case when a thick layer of frost is formed in the de-
vice, defrost it.
• Ambient temperature can affect power consumption.
Defrost
A thick layer of frost in the device increases the power con-
sumption. It is therefore recommended not to allow the
formation of a thick layer of frost and do the defrosting as
needed.
Manual defrosting
1. Turn off the device with the help of temperature regulator,
position «0».
2. Unplug the device.
3. Take out all the products. Then remove 2 upper contain-
ers, lower one leave for draining water.
4. Keep the door open.
5. Wait until frost and ice defrost.
6. Wipe the water with a dry cloth.
7. Thoroughly dry all the parts.
When defrosting do not use heating devices.
Follow the safety instruction in order not to
damage the cooling system.
In case of power outage do not place new
products into the device and try not to open the
door to keep the low temperature inside the de-
vice. If you know in advance about the power
outage, place in the top of the device several
containers with ice or frozen ice packs. If you
plan to be away for a long time on a vacation
or a long trip, remove all products and unplug
it. Wash and dry it.