Aux In Connection - auna Harper Bedienungsanleitung

EN
26
Removing of USB
To remove the USB, turn off the power then unplug it by pulling out the USB
socket directly.

AUX IN Connection

Connect the unit to any auxiliary device (i.e. MP3 player, or iPod® (not
included) by connecting the AUX IN jack (14) at the rear cabinet with one
end of 3.5 mm stereo cable (not provided) and the other end connect to the
auxiliary device to perform the music.
1. Slide function selector (18) to select "CD/AUX" mode.
2. Once the plug of the 3.5 mm stereo cable is inserted into the AUX IN
jack, the unit automatically switches to AUX mode.
3. Adjust the volume knob (17) to the desire volume level. If the distortion
is too high, reduce the volume level of your auxiliary device. Start to
playback your device.
NOTE: When connected to the AUX IN jack, the CD function will be disabled.
Unplug the AUX IN jack to resume CD playback function.
BT Connection and Playback
1. Set the function selector (18) to "Radio/BT" position and keep the BT/
FM selector (22) in "BT" position
2. The BT/USB LED indicator (10) will flash, which means the BT is not yet
connected and under searching mode.
3. Switch on the BT feature of your BT device (such as mobile phone) and
select "Harper" from the device list to connect.
4. Once the BT connection has been successfully established, the BT LED
(10) will light up.
5. You can start playback on your external BT device and let the music play
through the Boombox.