Package Contents; Led Functions; Getting Started - fontastic Xtaz Bedienungsanleitung

GB
User Manual
The wireless on-ear headphone Xtaz is your perfect companion
to listen to music and for phone calls.

Package contents

• Fontastic Headphone Xtaz
®
• Micro-USB charging cable
• This user manual
Overview
1. Speaker
2. Height adjustment
3. Headphone strap
4. Volume+ button | Next title
5. Multifunction button
(On/Off, Telephone,
Musik Start/Stop)
6. Volume- button | Previous title
7. Microphone
8. 3.5 mm Line-in connector
9. LED indicator
10. Micro USB connector

LED functions

Connected Blue lights up permanently
Not connected Blue and red flash alternately
Incoming call Blue lights up permanently
Charging Red lights up permanently
Pairing Blue and red flash alternately

Getting Started

Charging the battery
The Fontastic Xtaz is equipped with an internal rechargeable
®
battery. Connect the Xtaz with the micro USB cable which is
included in the package contents.
The cable can be connected to a computer or a standard USB
power supply. The Xtaz's red LED lights up during the charging
process. The usual charging time is 2-3 hours. When fully char-
ged, the red LED goes out. The cable can now be disconnected
from the Fontastic Xtaz.
®
Note: Charge Xtaz for at least 3-4 hours before initial use.
1
3
2
1
10 9 8 7
Adjusting the height / turning the speakers
Xtaz offers the possibility to adjust the loudspeakers in height to
the optimum position for you. To do this, hold the loudspeaker
unit up and pull the headphone strap (3) upwards. Adjust the
headphones in this way until the ear pads are exactly on the ear.
For comfortable wearing around the neck when the headphones
are not being used to listen to music, the speakers can be turned
outwards.
Switching On /Off
To switch on, press the multifunction button (5) for 3 seconds,
an acoustic signal sounds, the blue and red LED flash alternately.
To switch off, press the multifunction button (5) for 3 seconds,
an acoustic signal sounds,
the LED goes off.
Pairing
4
Xtaz must be paired with a Bluetooth
a two part process; one part is carried out on the headphone and
5
the other is carried out on the other Bluetooth
6
Note: Please note that different mobile phones may require
different pairing methods.
1. In the off state, press and hold the multifunction button (5) for
3 seconds to turn on. Keep the button pressed and wait until
the blue and red LED flashes alternately. This indicates the
pairing mode.
2. Use your Bluetooth
audio devices.
3. The Bluetooth
4. Confirm pairing with Xtaz. Enter „0000" if you are asked for
a pairing code.
If you are unsure about the pairing procedure of your Bluetooth
device, please check your device manual. When using a
Bluetooth transmitter without display, set it to pairing mode and
®
wait a few seconds until the connection with Xtaz is established.
Note: If the connection is lost or the transmitter is temporarily
disconnected, briefly press the multifunction button. Xtaz will
then try to restore the connection.
device before use. This is
®
®
enabled device to search for Bluetooth
®
device should indicate that it has found „Xtaz".
®
GB
device.
®
®
2