Installation And Use; Control Panel - KLIM Fresh Benutzerhandbuch

INSTALLATION AND USE

1. Unpack the package contents on a flat surface
2. Insert the 4 casters in the 4 sockets located at the bottom, pushing firmly to lock them in place
3. Place the cooler in a vertical position
4. Remove the two stripes of blue protective film located at the sides of the frontal panel
5. Lift the frontal lids manually using the socket located on the lower right part of the frontal panel
6. Fill the ice bottles with water and freeze them (see next page)
7. Fill the deposit with water and two frozen bottles (see next page)
8. Connect the power plug
9. Activate the fan using the bottons on the control panel (see section below)

CONTROL PANEL

These buttons control the fan speed. You can select either low (
medium ( ), or high (
the fan completely by pressing OFF (
While the fan is active, press the cool button (
cold air humidification mode. Press it again to deactivate it.
IMPORTANT: do not use this mode without enough water in the
deposit (see section "Filling the water deposit" on the next page).
While the fan is active, press the swivel (
change the direction of the wind from left to right. Press it again to
stop it in its current position.
Note: you can also adjust the vertical direction of the wind by
manually adjusting the lids on the frontal outlet.
3
) speed depending on your needs. Turn off
).
) button to automatically
)
)to activate the