Es gelten die Vorschriften und Sicherheitshinweise The regulations and safety instructions shall be gemäß dem Service Manual "Sicherheit", Material- valid as provided by the "Safety" Service Manual, nummer 72010 800 0000, sowie zusätzlich die even- part number 72010 800 0000, as well as the tuell abweichenden, landesspezifischen Vorschriften! respective national deviations.
Sicherheits-Hinweise Safety Advices Die in den Fernsehgeräten auftretende Röntgenstrahlung entspricht The X-radiation developing in the sets conforms to the X-radiation den Bestimmungen der Physikalisch-Technischen Bundesanstalt Regulations (January 8, 1987), issued by the Physikalisch-Techni- vom 8. Januar 1987. sche Bundesanstalt (federal physiotechnical institution). Die Hochspannung für die Bildröhre und die damit auftretende The high tension for the picture tube and thus the developing X- Röntgenstrahlung ist abhängig von der exakten Einstellung der...
GB Circuit Diagram Symbols Schaltplansymbole Symboles schéma Simboli sullo schema Simbolos en los esquemas B/50 Feinabst. + / Fine tuning + / Réglage fine + / Sint. fine + / Sint. fina + Blau - Signal - 50Hz vert.,15625Hz hor. / Blue signal - 50Hz vert., 15625Hz hor.
Seite 6
FBAS FBAS-Signal / CCVS signal / Signal vidéo composite / Segnale video Infrarot-Signal / Signal infrared / Signal infra-rouge / Segnale composito / señal video compuesta infrarosso / Señal infrarojo. FBAS FBAS-Signal-Cinch Buchse / CCVS signal-cinch socket / FBAS- C Bus -Clock CINCH CLOCK prise à...
Seite 7
VIDEO Strahlstrombegrenzung / Beam current lim. / Lim. cour. de faisceau / Video Signal / Video signal / Signal vidéo / Segnale video / Señal video Lim. corr. di raggio / Corriente media de haz VT DATA C-Bus Clock Videotext Daten / Teletext data / Données Teletexte / Linea dati Televideo / Data Teletexto SCL 100 VT SCL...
Seite 8
déviation / Tens. commut. deviazione / Tens. conmut. deviacion video IDENT WISCH Schaltspg. Signalkennung AV 3 / Switching volt. signal identification Schaltspg. Wischerkontakt / Schwitching voltage temp. contact / AV 3 / Tens de commut.identification de signal AV3 / Tens. commut. Tens.
Service- und Sonderfunktionen 1. Sonderfunktionen 1.1 Analogwertspeicherung 2.5 Decoder Eingestellte Analogwerte werden automatisch nach ca. 8 Sekunden Über das Servicemenü Decoder "ON" oder "OFF" schalten. oder durch Schalten in den Standby-Betrieb gespeichert. Decoder "ON": Automatische Erkennung der Schaltspannung an Pin 8 der EURO-AV- 1.2 Optimalwerte einstellen, Buchse (z.B.
Service and Special Functions 1. Special Functions 1.1 Storing the Analog Values 2.5 Decoder The entered analog values are either stored automatically after approx. Via the Service Menu switch the decoder "ON" or "OFF". 8 seconds or when switching to standby mode. Decoder "ON": Automatic identification of the switching voltage at Pin 8 of the EURO- 1.2 Setting the Optimum Values...
Schaltungsbeschreibung 1. Netzteil 1.1 Prinzipschaltung Die Ansteuerung sowie die Regel- und Überwachungsfunktionen des Sperrwandler können subharmonische Schwingungen aufweisen wenn bipolaren Leistungstransistors T665 übernimmt der IC630. Die Versor- sie mit einem Arbeitstakt > 50% bei kontinuierlichem Induktionsstrom gungsspannung des Regel-ICs (Pin 7) liegt bei 12V. Nach dem betrieben werden.
UC 3842A V cc V in V cc V ref Reference Regulator V cc Internal UVLO Bias 2.5V V ref 3.6V UVLO T665 Output Oscillator 1.0mA Power Ground Voltage Feedback Input Error 1.0V Latch Current Sense Input Amplifier Output Current Sense Compensation Comparator = Sink Only...
3. TV-Signalprozessor TDA8362A Signalprozessors. Die Demodulation des FBAS-Signals erfolgt in 3.1 Übersicht einem Produktdemodulator. Der dafür benötigte Demodulatorkreis Bei diesem TV Konzept erfolgt fast die gesamte Verarbeitung des F130 liegt an Pin 2 und Pin 3. Das demodulierte Signal durchläuft Signals in einem einzigen IC, dem TV Signalprozessor TDA8362A.
Seite 14
3.5 Ton-ZF nun die Farbkomponentensignale demoduliert und verlassen als R-Y (Pin 30) und B-Y (Pin 31) den IC150. Nach der PAL-Verzögerung Dem Tonsignal ist nach dem Keramikfilter F926 an IC150-(5) eine Gleichspannung zur Einstellung der Lautstärke unterlegt. Die durch den CIC105 TDA4665 werden die beiden Signale B-Y und R-Y Demodulation erfolgt in einem PLL Demodulator.
3.8 RGB-Signalweg 3.10 Zeilenoszillator Für die Kontrasteinstellung der RGB-Signale erzeugt der IC850-(23) Bei diesem IC-Konzept generiert der Zeilenoszillator die Zeilenfrequenz eine variable Regelspannung für den Kontrastverstärker an IC150-(25). vollständig intern. Er besitzt keine externen Bauteile. Somit sind weder Da bei zu großem Strahlstrom die Bildröhre beschädigt werden die freilaufende Horizontal- noch die freilaufende Vertikalfrequenz könnte, begrenzt die Schaltung den Strahlstrom.
3.13 Supersandcastle SSC Wird ein Synchronsignal empfangen, dann läuft zunächst der Zeilen- oszillator synchron. Der Zeilenzähler liefert auch hier ein vertikales Das 3-pegelige Supersandcastlesignal IC150-(38) ist ein Kombi- Impuls bestehend aus dem Horizontal-, Vertikal- und Burst- Ablenksignal. Kommt nun ein Vertikalsynchronsignal, wird der auftastimpuls.
Circuit Description 1. Power Supply 1.1 Basic Circuit The IC630 is responsible for driving, controlling and monitoring the Current mode converters can exhibit subharmonic oscillations when bipolar power transistor T665. The supply for the control-IC is 12V and operating at a duty cycle greater than 50% with continuous inductor is present on Pin 7.
UC 3842A V cc V in V cc V ref Reference Regulator V cc Internal UVLO Bias 2.5V V ref 3.6V UVLO T665 Output Oscillator 1.0mA Power Ground Voltage Feedback Input Error 1.0V Latch Current Sense Input Amplifier Output Current Sense Compensation Comparator = Sink Only...
demodulation of the CCVS signal is carried out in a product demodulator. 3. TV Signal Processor TDA8362A The required demodulator circuit F130 is connected to Pin 2 and Pin 3. The demodulated signal passes through an amplifier and is then 3.1 Overview: With this TV design the whole signal processing is carried out in a present at Pin 7 of the IC (BB).
Seite 20
3.5 Sound IF demodulated and leave IC150 as R-Y and B-Y signals at Pin 30 and Pin 31 respectively. Following the PAL delay at CIC105 TDA4665 the After the ceramic filter F926, the sound signal is superimposed at IC150-(5) on a direct voltage for setting the volume level. Demodula- two signals, B-Y and R-Y, are fed back to IC150-(28), -(29) TDA8362A tion is effected by a PLL demodulator.
Seite 21
3.8 RGB Signal Path 3.10 Line Oscillator For contrast control of the RGB signals, IC850-(23) generates a With this IC concept, the line frequency is generated completely inside variable control voltage for the contrast controlling amplifier at the line oscillator. The IC is not connected to external components so IC150-(25).
Seite 22
3.13 The Super Sand Castle - SSC On reception of a synchronising signal, the line oscillator will first be synchronised. In this case too, the line counter supplies a field deflec- The 3-level SSC signal IC150-(38) is a composite pulse consisting of the line flyback, the field flyback, and the burst key pulses.
Seite 23
Abgleich Alle nicht beschriebenen Einstellelemente sind werkseitig abgeglichen und dürfen im Servicefall nicht verstellt werden. Messgeräte: 100MHz Oszilloskop mit Tastkopf 10:1, HF-Millivoltmeter, Farbbildgenerator, hochohmiges Voltmeter. Kontrolle und Einstellarbeiten nach Austausch bzw. Reparatur von: Netzteil: Abgleich 1 Zeilenablenkung: Abgleich 6, 7, 8 Bildröhre: Abgleich 5, 6, 7, 8 IC150: Abgleich 2, 3, 8 ZF: Abgleich 2, 3...
Alignment All adjustment controls not mentioned in this description are adjusted during production and must not be re-adjusted in the case of repairs. Measuring Instruments: 100MHz oscilloscope with 10:1 test probe, RF millivoltmeter, colour test pattern, high resistance voltmeter Checks and adjustments after replacement or repair of: Power Supply: Alignment 1 Horizontal Deflection: Alignment 6, 7, 8 Picture Tube: Alignment 5, 6, 7, 8...
Platinenabbildungen und Schaltpläne / Layout of the PCBs and Circuit Diagrams Chassisplatte Chassis Board Koordinaten für die Bauteile der Bestückungsseite (Oberseite) Coordinates of the Components on the Components Side (Top Side) Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/...
Seite 26
Chassisplatte Chassis Board Koordinaten für die Bauteile der Lötseite (Unterseite) Coordinates of the components on the Solder Side (Bottom Side) Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos.-Nr./ Koordinaten/ Pos. No. Coordinates Pos. No. Coordinates Pos. No. Coordinates Pos.
Seite 27
Chassisplatte Chassis Board 29304-764.71/4B(08) C532 C682 TR550 KEINE NETZTRENNUNG TR601 L646 BR646 ST-BAT2 SI600 T2,5A D666 NETZ Bestückungsseite, Ansicht von oben C0682 Component Side, Top View NETZ2 BR181 D664 R661 NETZ1 NETZ3 S601 TRX550 U G2 BR600 C667 BR601 R633 ORION 14"...
Seite 40
POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NO. PART NUMBER DESCRIPTION POS. NO. PART NUMBER DESCRIPTION D 00621 83092 151 2700 DIODE 1 N 4007 -GA R 00609 83112 000 2000 PTC RM5 B59.250C1080 D 00622 83092 151 2700 DIODE 1 N 4007 -GA R 00627 87650 491 6100 MSW SI 0414 4,7 MOHM VDE D 00623...
Seite 42
POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NO. PART NUMBER DESCRIPTION POS. NO. PART NUMBER DESCRIPTION D 00324 83092 150 4500 DIODE 1N4148 R 00502 87053 290 7000 MOW 0411 150 OHM 10% D 00401 83092 101 3800 DIODE 1N4936 R 00504 87011 210 3300 KSW SI B 22 OHM 5% D 00405...
Seite 44
POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NO. PART NUMBER DESCRIPTION POS. NO. PART NUMBER DESCRIPTION D 00543 83092 042 6800 DIODE BYV16 R 00543 87053 290 2500 MOW 0411 10 OHM 5% D 00621 83092 151 2700 DIODE 1 N 4007 -GA R 00554 87053 210 2200 MOW 0411 7,5 OHM 5% D 00622...
Seite 46
POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NR. MATERIAL-NR. BEZEICHNUNG POS. NO. PART NUMBER DESCRIPTION POS. NO. PART NUMBER DESCRIPTION D 00621 83092 151 2700 DIODE 1 N 4007 -GA R 00554 87053 210 1300 MOW 0411 3,3 OHM 5% D 00622 83092 151 2700 DIODE 1 N 4007 -GA R 00609 83112 000 2000 PTC RM5 B59.250C1080...