INTERTECHNO ITL-230 Bedienungsanleitung Seite 12

GB
The wireless module ITL-230 can be installed behind any existing light switch and is
suitable for all types of lamps (including LEDs) up to max. 230 Watt.
The lights can therefore be switched on and off using the light switch and by
remote control.
If the radio module is installed in the supply line without a light switch, the 2 white
connecting wires must be insulated separately.
Do not cut off!!!
All intertechno radio transmitters beginning with the year of manufacture 1995
can be used.
Teaching transmitters (67 million different codes) as well as radio transmitters
with coding wheel (256 coding options) are available.
Please ask your local dealer!
A franchise electrician has to conduct the installation.
Installation
1.) Switch off main fuse.
2.) Remove existing light switch and disconnect cable. Fig. 2
3.) Connect power supply and output to the radio module (a+b) in Fig. 1
4.) Connect the 2 cables (c) at the light switch. Fig. 3
Coding
5.) Switch on main fuse, prepare desired IT-transmitter.
6.) Shortly press (approx. 1 second) learning button (d) with a fine wire nail
(e.g.: paper clip, ball-pen). Fig. 4
7.) LED (e) starts flashing. Now press button "EIN (ON)" at transmitter
until the connected light lights twice. DONE!
8.) Switch off main fuse and install light switch with radio module.
9.) Switch on main fuse.
It is possible to store up to 6 different codes.
Even when there is a power failure these remain stored.
Using several radio modules results in several
circuit options as single or group circuit.
Deleting individual codes
Start as in 5.) and press button "AUS (OFF)" instead of "EIN (ON)"
at the transmitter. The code is deleted.
Deleting all codes
Start as in 5.). Press learning button for approx. 6 seconds until
the LED flashes.
Then press it again shortly. All codes are deleted.
To view the declaration of conformity, please visit www.intertechno.at/CE
Operating instructions
ITL-230