Icy Box IB-EW206B-T Handbuch Seite 10

Digital Touch-Control Panel
Note: When using the control panel for the first time, please reset the system before any other operation.
Reset the system:
• To reset the system, press and hold the "Up" and "Down" buttons simultaneously. The unit emits one beep and the display shows
" " and the desk starts moving downward to the lowest position. Do not release the buttons until the unit emits a second beep.
The desk will move upward a little and the display shows the current desk height. The reset process is finished.
Height adjustment:
Press and hold the "UP"/"DOWN" button to lift/lower the desk to your desired height. Press and release the button to lift/lower the desk precisely.
Timer:
• Press the „T" button to set the time at which you want to be reminded to stand up. Each press of the "T" button results in a 0.5 hour increment. The maximum setting for the reminder time is 2 hours. After
setting a time, the display flashes for a few seconds and then automatically shows the height of the table again. The indicator light at the top right of the control panel lights up.
• 5 beeps sound when the reminder time is reached.
• To deactivate the timer again, press the „T" key repeatedly until the control light in the display goes out again.
Memory setting:
• To save altitude settings, press the „M" button and "
• To recall a stored position, press memory button 1, 2 or 3 and the table will move to the desired height. During the „UP and DOWN" movement, the corresponding height units are shown in the display. To
stop the movement, press any key.
Setting up the display lock:
• For safety reasons this control panel has a lock function. To activate / cancel the lock function, follow the "PART3-Custom Programming Guide: To Change the Screen Lock Function".
• To lock the control, press "M" for 3 seconds. When the control is locked, only a bar "
• To unlock the touch controller, press „M" again for 3 seconds. The display now shows the current height position. 1 minute after the last input, the touch controller is locked again.
Switch between centimeters and inch:
Press and hold the "T" key for approx. 3 seconds and the current unit of measurement changes to the other.
Energy-saving mode:
If no input is made for more than 10 minutes, the touch controller will go into power saving mode and the display becomes dark. Touch any key to reactivate the control panel.
Manual
" appears in the display. While the display shows "
" is shown in the display and any operation is invalid.
", press button 1, 2 or 3 to store the corresponding height position.