Werbung
Verfügbare Sprachen
Verfügbare Sprachen
The automatic (auto) search
The auto search function searches through all the codes to find the one corresponding to
the selected device.
1
Switch on the device you
On your remote control, press
want to control with the
and hold the key of the device
remote and aim the remote
for 3 seconds (example:
at the device.
the TV key
located on the top part of the
remote will turn on and then
turn off after 3 seconds.
4
Try some keys on your remote
When the device turns itself
control to check if they work
off, the correct code has been
found. Press the device key
properly. If they do, your settings
right away to store the code
were successful: you found the
right code. You are now ready
and exit the search. The LED
to set another device, with the
slowly flashes four times then
same procedure.
goes off.
quick quide.indd 2
All manuals and user guides at all-guides.com
2
3 sec
Release the key. The LED
lights up again. Press the
Play key
: the LED starts
). The LED
TV
flashing and the auto search
begins. A new code is sent
by the remote control every
second.
5
It is recommended to use both the auto search and the quick search methods. Use the quick
search if you didn't have the time to store the correct code during step 4 of the auto search.
3
1
Press the Pause key
Press the
during the auto search
quick search.
to enter the quick search
mode. The LED remains
on.
4
When the device turns on, the correct code has
been found. Promptly press the corresponding
device key on the remote control to store the code
and exit. The LED slowly flashes four times then
goes off.
Note: If you accidentally pressed on the
after the device has turned on, press on the
key right away and wait for 2 seconds to see if
your device turns off.
NOTE: If you have troubles programming your remote control, you can also refer to the
"Tips for auto and quick search modes" section of the instruction manual (p.12).
The quick search
2
CH _
key to start the
The device you want to
program on the remote control
should turn on. If the device
does not turn on, press the
key every 2 seconds until it
does.
5
Check whether all applications
of your device can be operated
with the remote control keys.
You are now ready to set
another device, with the same
CH _
procedure.
key
+
CH
3
2 sec
CH _
2/4/08 19:18:03
Werbung
