Product Disposal - Tracer TRAOSW46830 Bedienungsanleitung

Solar garden garland TRACER 30 LED 30 bulbs
EN
Instruction manual
Please read and retain for future reference the following carefully to
ensure the satisfactory and safe operation of the light.
Note:
• Before the first use, remove all packaging elements.
• Unwind and straighten the USB cable before use.
• Make sure that the USB cable has no visible damage.
• Make sure that the cable is not stretched over an open flame or other
heat source that may damage the cable insulation.
• The cable must be positioned so as not to present a risk of tripping or
entanglement
• This product is not a toy. Make sure children are supervised and do not
play with the product
• This device is not intended for use by persons (including young
children) with reduced physical, sensory or mental abilities or without
experience and knowledge, unless they are supervised or instructed in
the use of the device by a person responsible for their safety.
1. Package includes:
Garland with solar panel
Fixing panel
Pole
Instruction manual
2. Solar panel operation
During the day, the solar panel converts sunlight into electricity and
recharges the batteries. At night, the light turns on automatically using
the electricity stored during the day.
The number of hours the light stays on depends on your geographical
location, weather conditions and seasonal sunlight availability.
2.1 Attach the pole to the fixing panel (picture 1)
2.2 Slide the solar panel box in to the top of the fixing panel (picture 2)
2.3 Press ON/ OFF button to switch the garland on/off. Press „mode" to
change the flashing styles.
Picture 1 Picture 2
3. Use direction
3.1. Before the first time use we advise to keep the light OFF during the
first 24 hours in orderto charge the battery well
3.2. Place the solar panel in a location where it can receive a full 8
hours of sunshine to allow the rechargeable battery to reach
maximum capacity. Please make sure there is no any objects that
may cover the solar panel and cause shadow on it.
3.3. After 24 hours set the switch to the "ON" position.
3.4. When it is dark the garland should turn on automatically
3.5. The duration of the garland light depends on the battery charge
level, if baterry is fully charged it should light 6-8 h hours.
Please note that the battery cannot fully charge on a rainy and cloudy
days or days where there was not much direct sunlight.
The battery needs 8 hours of direct sun's rays to get fully charged.
4. Troubleshooting and Caution
If your solar light does not operate properly at night, it may be caused
by one of the following:
• Ensure that the solar panel is in a bright sunny location.
• Make sure that the switch is turned on.
• Other lights can cause flickering in a solar light or even prevent it
operating.
Note:
1. The light source of this luminaire is not replaceable; when the light
source is worn out, the entire lighting fitting must be replaced
2. The product is safe for outdoor use. Waterproof grade -IP44
3. For winter and autumn or time where garland is not in plan to be used
we advise to store your light indoor until next season. Please clean
and dry the solar panel, turn off the switch. Store in a dry spot and
reassemble in spring as described in point „ 3. Use direction „
Safe use instruction
1. Do not cover the lamp with any objects.
2. Do not pull the power cable
3. Be careful with hot surfaces
4. Do not stare at the light source
5. Do not touch with wet hands
6. Do not throw it
7. The product is not a toy
Parameters:
Supply voltage: DC 1.2V
Max. LED power: 1,8 W
Solar panel type: polycrystalline
Battery type: ni-mh aa
Battery capacity: 600mAh
LED type and qty: Non-replaceable light source SMD x 30 pcs
Working temperature: -10-50°C
Product's life time: 10 000h
Lamp dimensions: 650 x 7 x 22cm
Net weight: 350g
Material: ABS
Ingress Protection: IP44

Product disposal:

1. Packaging components in the form of paper, cardboard and similar
materials should be transferred to waste paper or thrown into waste
containers intended for paper
2. Plastic elements such as polystyrene, films, granular fillers and similar
Picture 3
should be thrown into containers intended for plastics
3. A worn out or permanently damaged lighting fitting may not be disposed
with general waste. Due to the presence of hazardous substances, it
should be handed over to an appropriate recycling place for electrical
and electronic waste.