Slackers Ninjatimer Bedienungsanleitung Seite 2

STEP 1. INSTALL BATTERIES
• Open the back compartment with a small screwdriver
• Insert batteries as shown at the right side.
• Exceptionally use batteries AA with 1.5 V.
STEP 2: DETERMINE WHERE YOU WANT TO INSTALL THE TIMER
Option 1 - Installation on a flat surface: place the timer on a flat surface, such as a table. B. on a table,
a chair, etc. The smallest user must be able to operate the timer (height selection). Make sure to set up
the timer and the stand at least 3m / 118 inch away from the play course.
Option 2 - Installation of a wooden substructure: buy a 10cm x 10cm / 4 inch x 4 inch squared timbers in
a DIY market and build a stand for the timer (see two suggestions below):
Option 3 - Attach to the side of a tree: determine where you want the timer to hang. Height should be
able to be reached by the shortest user. Use a drill to make a hole slightly larger than the diameter of the
screw. Tools are not included. Place screw into the hole and leave about 12mm / 0,5 inch of the screw
out so you can hang the timer. Hang the timer off the screw. Please never use options 2 and 3 in public
areas unless you have express permission to do so. Assembly only on private property.
WARNING! THIS PRODUCT MUST BE UNPACKED AND INSTALLED BY AN ADULT.
If you have any questions about your product please contact us: info@mts-sport.de
IMPORTEUR: MTS Sportartikel Vertriebs GmbH, Hans-Urmiller-Ring 11, D-82515 Wolfratshausen, Germany
WARNING! NEVER PLACE THE TIMER ON THE FLOOR.
THERE IS A RISK OF INJURY FROM TRUMPING.
MANUFACTURER: B4Adventure, Denver, CO 80216