SL RF NANO CANYON Montageanleitung & Sicherheitshinweise Seite 8

Assembly
1. Position one o-ring between lamphead and quickrelease, and one o-ring
between quickrelease and screw.
For a centric installation at 50mm stems, there's a stem kit
(Art.No. 5355) available.
2. Mount the quickrelease on to the
lamphead.
Note: The screw should be attached
pretty easily. If not, please try to
postition it and screw it on again.
Otherwise the thread can be da-
maged.
3. Position the lamp centric at the
handlebar. Now close the bracket of
the quickrelease so the SL is mounted
tight in its position.
Adjustment of the lamp:
Height of the light cone after
5m: Half height as outlet
Height for Mounting: 400-1200mm
Note: For proper setup screw on the
lever of the quickrelease mount.
4. Finally connect the USB-C cable
to the intended socket.
1/2
5m: