Analysis Procedure - Foss Infratec Sofia Bedienungsanleitung

4.2

Analysis Procedure

1. Pour the sample (up to 0.4 l) into the hopper.
2. If the pre-selected product (grain type) is correct – proceed to step 4.
Fig. 4:5 "Analyze" view
3. To select another product than the pre-selected, press the soft key "Grain" and
use the "Arrow" keys to scroll through the list of available products until the
correct product is highlighted. Press Select to confirm selection and return to the
"Analyze" view or press Cancel to return to previous screen
Fig. 4:6 Select product view
4. Press the - key.
5. Register additional information to the sample with User Defined Fields, UDFs
(optional). Refer to section 4.2.2 User Defined Fields. The UDF icon is visible
in the upper right corner of the display indicating UDF's have been selected.
6. Press the - key again. It takes approximately 3 minutes to complete an
analysis. During analysis a progress bar is shown together with information
about the selected product.
4:4
Infratec™ Sofia
User Manual 6002 5350 / Rev. 6