Werbung
Verfügbare Sprachen
Verfügbare Sprachen
User manual
Battery LED light set: 24sevenStop
Congratulations on the purchase of your new device. The user's manual is part of
this device and contains important information to safety, installation and disposal.
Familiarize yourself with all operating and safety instructions before using the device.
Use the device as described and in the specified areas of application. Keep this
manual in a safe place and have it with you when using the device.
Used symbols
Symbol: „Der grüne Punkt"
Recycling the packaging
Symbol: crossed-out garbage can
Do not dispose electrical and electronic equipment in the
domestic waste
Symbol: crossed-out garbage can
Do not dispose batteries / rechargeable batteries in the
domestic waste
Symbol: USB – universal serial bus
Connecting point for charging the LED lights
XXXX
Symbol: Test mark of the German Federal Motor
K
Transport Authority
Proper use
The product is intended for use on bicycles and serves the illumination of the road.
This LED front light and the LED tail light are approved according to the currently
valid RTLR (StVZO) as a sole lighting on all bikes. The product is intended for outdoor
use. Any other use than described above or alteration of the product is not permitted
and may cause damage to the product. The manufacturer assumes no liability for
damage arising from improper use. The product is not intended for commercial use.
Safety information
- Do not look into the LEDs of the front - or tail light.
- Do not point the LED front light directly at people or animals.
- The light beam of the LED front light must point straight in direction and should not
blind other road users.
- The tail lamp should be mounted and adjusted so that the reference axis is parallel
to the vehicle's median longitudinal plane and parallel to the road surface.
- The light distribution may be obscured by no other attached parts or pieces of
luggage, not even partially.
- The LEDs are not interchangeable. If the LED fails, the entire luminaire must be
replaced.
- Change the batteries immediately when the battery indicator light turns red.
WARNING! LIFE AND ACCIDENT HAZARD FOR INFANTS AND CHILDREN!
Never leave children unattended with the packaging material, because of suffocation
danger by swallowing packaging parts. Always keep the device away from children.
The device is not a toy! This device can be used by children of age 8 and over and
by persons with reduced physical or mental capabilities or lack of experience and
knowledge if they have been supervised or instructed concerning the safe use of the
device and by understanding resulting hazards. Children are not allowed to play with
the device. Cleaning and user maintenance should not be carried out by children
without supervision. Do not disassemble the device. Improper repairs can cause
significant risks for the user. Only have repairing made by qualified personnel.
Safety information of the batteries
- Cells or batteries should not be short-circuited. Cells or batteries should not be
stored safely in a box or in a drawer where they may short-circuit each other or be
short-circuited by other conductive materials
Manual_24sevenStop_2020-01 EN
- Cells or batteries should not be subjected to mechanical shocks.
- If a cell leaks, make sure the fluid does not get in contact with the skin or get into
the eyes. If contact has occurred, wash the affected area with plenty of water and
seek medical help.
- Cells or batteries that are not designed to use with the device should not be used.
- After prolonged storage, it may be necessary to charge and discharge the cells or
batteries several times for full performance.
- Do not ignite the battery or expose it to combustion. Avoid the storage in direct
sunlight.
- For an optimal battery performance, avoid deep discharge cycles! Charge your
battery often.
- Batteries do not discharge deeply! Deep discharging damages the battery cells!
The most common cause for the discharge of battery packs is long storage or non-
use of partially discharged batteries. End the work process as soon as the power
noticeably declines or the protection electronics respond. Store the battery only
after full charge.
- Do not overcharge the batteries! Observe the maximum load times. These charging
times apply only to discharged batteries. Multiple insertion of a charged or partially
charged battery leads to overcharging and cell damage. Do not leave batteries in
the charger for several days.
- Cells and batteries do not load for longer time if they are not used.
- Cells and batteries have the best performance when operated at normal room
temperature.
- No other chargers may be used than those which are specifically intended for use
with the equipment.
- If the connections of cells or batteries are dirty, clean with a dry, clean cloth
Front light
Product illustration
front light
1
2
on/off switch
sensor
3
4
battery control device
front light lock
5
6
bracket
USB charging bushing
7
8
sensor indicator light
Tail light
⑥
⑤
Assembly of the front light
Position and secure the bracket (6) at the desired position on the handlebar. Tighten
the rubber flap and hook it in. To put the optimum corner to the direction of the traffic
you can twist the front light in the holder without tools. Slide the front light (1) onto
the bracket (6) until it clicks into place. To release, press the front light lock (5) and
push the front light (1) forward from the bracket (6).
⑦
Rear light assembly
Position and fasten the rear light (1). to the seat post using the rubber strap 6. of
①
the bracket (5). Pull the rubber strap (6). of the bracket (5). tightly and hook it in.
⑤
Attention: Always make sure that the rear light is mounted as shown on the
illustration.
⑥
Front light adjustment
②
③
8
④
Align the LED front light so that the light beam reaches the road approx. 10 meters
in front of the wheel (see ill.). Attention! Check regularly the correct setting of your
front light. The light beam of the LED front light must point straight in direction and
should not blind other road users.
①
②
③④
Werbung
