Xsarius Doorcam pro Gebrauchsanweisung Seite 10

2. How to pair and unpair the indoor unit with the doorbell
1 Pair : Plug the indoor unit into power and wait when the blue light is always
on , and then press the doorbell button, when the indoor unit 's blue light
turns to flash, then the pairing is completed. (you can switch the ringtone by
pressing music button on the indoor unit )
Unpair: Uplug the paired indoor unit and press and hold the volume button
2
then plug into the power again until the blue light is always on which indicates
the doorbell and indoor unit have been successfully unpaired.
3. Camera Installation Method
Special Note:
1 Keep the doorbell, indoor unit and router as close as possible (to avoid
network failure due to too far).
2
The installation height of the doorbell is 1.2~1.5 meters.
3 It should be installed on non-metallic materials (to avoid signal shielding), and
it is recommended to stick it on the side wall of the door.
Installation method 1: glue on the wall and fix it (recommended)
1 Tear off the red 3M adhesive sticker at the bottom of the upper wall base,
and then paste the upper wall base on a smooth wall (such as glass, ceramic
tiles, latex wall paint, etc.)
Hang the doorbell from top to bottom on the base of the upper wall to
2
complete the installation.
Note: The adhesive can only play 100% viscosity after 24 hours after it is glued.
9
2
1
Doorbell
Base
Wall space