Herunterladen Diese Seite drucken

M-WAVE ATLAS K10 USB Montageanleitung Seite 2

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

Rear Light/ Rücklicht
25cm minimum distance to ground
25cm Mindestabstand zur Fahrbahn
USB port
USB Ladebuchse
seat post
Sattelstütze
Mounting parallel with the ground and
with the longitudinal axis of the vehicle
Ausrichtung parallel zur Fahrbahn
und zur Fahrzeuglängsachse
vertical to drive way
1,5°
vertikal zur Fahrbahn
drive way
Fahrbahn
approval number
Genehmigungsnummer
EN
Headlight: Integrated accumulator 3,7V 900mAh - not changeable.
Rear Light: Integrated accumulator 3,6V 160mAh - not changeable.
Perform a full charge before the first use.
Always charge with provided USB cable.
1. When the red battery level indicator light turns on, the accumulator must be
charged immediately.
If the battery has been completely run down it will take up
to 20 seconds for the recharge light to come on after connecting the USB cable.
The accumulator is fully charged when
the indicator light turns green. Please
ensure you unplug the USB cable after completion.
2. DO NOT use this product while recharging.
3. DO NOT charge the battery for more than 15 hours consecutively.
4. Before every use of the light, please make sure the accumulator is not flat.
5. Tested and approved in line with German national road traffic regulations.
6. The lamp set must be firmly connected to the bicycle. The light distribution
must not be obstructed by any part of the vehicle.
7. The lighting unit should be exchanged, if the battery level indicator turns on
within one hour, although the accumulator was fully charged. Upon failure of one
of the light-emitting diodes, the complete lighting unit needs to be exchanged.

Werbung

loading