Inhaltsverzeichnis
Werbung
Verfügbare Sprachen
Verfügbare Sprachen
b) Remove the light fixture
Surface mounting
Risk of electric shock!
•
Before installation, maintenance, or removal, always switch the electricity supply and corre-
sponding circuit breaker and/or automatic fuse OFF.
•
Secure against unauthorized restart, e.g. by installing a warning sign.
•
Check the power circuit for any remaining voltage using an appropriate measuring device.
a) Installation
Attach the bracket to the ceiling.
Switch the electricity supply ON
•
Switch the corresponding circuit breaker and/
or automatic fuse back ON.
•
If the light does not light up, switch OFF power
to the circuit immediately.
•
Switch OFF the circuit breaker and/or auto-
matic fuse.
•
Check the connection to the power circuit.
Risk of electric shock!
Observe the safety information given at the begin-
ing of this section.
Carefully pull the fixture out from both sides as
shown.
1. Attach the safety wire to the light and bracket.
2. Connect the light to the power supply.
3. Press the light fixture onto the bracket.
Switch the electricity supply ON
•
Switch the corresponding circuit breaker and/
or automatic fuse back ON.
•
If the light does not light up, switch OFF power
to the circuit immediately.
•
Switch OFF the circuit breaker and/or auto-
matic fuse.
•
Check the connection to the power circuit.
b) Remove the light fixture
Risk of electric shock! Obeserve the safety information given at the begining of this section.
Press here
Press one side of the light fixture (perpendicular to
the bracket). Then carefully remove from the op-
posite side.
Care and cleaning
•
Switch the electrcity supply off before each cleaning.
•
Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
•
Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines. You thus fulfill your statutory obligations and contribute to the protection of the envi-
ronment.
Technical data
Input voltage / current ........................... 200 - 240 V/AC, 50/60 Hz
Power consumption .............................. 18 W
Material ................................................. Thermal plastic
Cut-out mounting .................................. Bracket width: 55 -170 mm
Integrated LED driver ........................... yes
Integrated heat sink .............................. aluminium
Mode settings ....................................... Switch: use wall switch to adjust colour temp.
CW: cool white, NW: natural white, WW: warm white
Correlated color temperature (CCT) ..... 3000 K (warm), 4000 K (natural), 6500 K (cool)
Protection class .................................... II
Dimmable ............................................. no
Operating/Storage conditions ............... -20 to +40 ºC, 10 – 80 % RH (non-condensing)
Dimensions (L x W x H) ........................ ø217 x 15 mm
Weight .................................................. 330 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2021 by Conrad Electronic SE.
Do not pull the light fixture off the bracket from
one side. This will cause damage!
*2335669_v2_0321_02_dh_m_en
Werbung
Inhaltsverzeichnis
