Denon Professional DN-300Z Benutzerhandbuch Seite 9

Setup / Connection Diagram
4. 5.
FM Antenna
AM Antenna Loop
Important: Connect all cables securely and properly (with stereo cables: left with left, right with right), and do not
bundle them with the power cable.
1. Use a stereo RCA cable to connect the Tuner Outputs (unbalanced) to the analog inputs of your external
receiver, amp, etc. Make sure the Tuner Region Select Switch is set to the number for your location: 1 (North
and South America, 2 (Europe and Asia Pacific region), or 3 (Japan).
Note: If the unit's power is on, turn the power off and on again. If the unit is powered on, turn its power off and
on again after changing this setting. When the unit powers on again, it will be set for the selected area.
2. Use a stereo RCA cable to connect the CD/USB/SD/AUX/BT Outputs (unbalanced) to the analog inputs of your
external receiver, amp, etc.
3. Connect the included Bluetooth antenna to the Bluetooth Antenna Terminal.
4. Connect the included FM antenna to the FM Antenna Terminal.
5. Connect the included AM antenna loop to the AM Antenna Terminals.
Make sure the AM loop antenna lead terminals do not touch metal
parts of the panel. (Even if you use an external AM antenna, do not
disconnect the AM loop antenna.)
If you want to hang the AM antenna loop on a wall, use a nail or tack to attach it (unassembled) to the wall.
If you want to stand the AM antenna loop on a flat surface, assemble it (see images below):
i. Put the stand section through the bottom of the loop antenna from the rear and bend it forward.
ii. Insert the projecting part into the square hole in the stand.
6. After completing all the connections, use the included power cable to connect the AC In to a power outlet.
i.
AM Loop
Antenna
1. 2.
Receiver, amp, etc.
Stand
Square
hole
Projecting
part
3.
Bluetooth Antenna
Items not listed under the Box Contents are sold separately.
ii.
6.
Power
9