JBM 51035 Bedienungsanleitung Seite 5

STEP 3
Fix the display board (C) onto the 2 frames (F)
assembled in the previous step:
• Lower part: insert the 2 bolts (K) through
the holes of the frame (F) and iron plate
(G), and tighten them using the 2 hexago-
nal nuts (L).
• Upper part: insert the 2 bolts (K) through
the holes of the frame (F), and tighten them
using the 2 hexagonal nuts (L).
Parts needed:
C x 1pc
K x 8pcs
L x 8pcs
STEP 4
Fix the tray (E) onto the display board (C). Use
2 bolts (K) and 2 hexagonal nuts (L) to fix each
of the ends of the tray (E) in place as illustrated
in the figure
Parts needed:
K x 4pcs
L x 4pcs
STEP 5
To assemble the receptacle (R) (not supplied),
fix the 2 clips (P) onto the display board (C)
using the 2 bolts (Q) and 2 nuts (M) as illustra-
ted in the figure.
Parts needed:
M x 2pcs
P x 2pcs
Q x 2pcs
R x 1pcs
STEP 6
To assemble the lamp (S) (not supplied), fix it
onto the tray (E) using the nuts (M), hexagonal
nuts (N) and bolts (O) as illustrated in the figure.
Parts needed:
M x 4pcs
N x 4pcs
O x 4pcs
S x 2pcs
· 5 ·