Heitronic 501000 Installations- Und Bedienungsanweisung Seite 2

8. Technische Daten
Artikel Anschluss Ausführung
501000 220-240 V~AC 50Hz 400mm weiß
501001 220-240 V~AC 50Hz 400mm granit
501002 220-240 V~AC 50Hz 700mm weiß
501003 220-240 V~AC 50Hz 700mm granit
9. Pflege
•
Schalten Sie erst das gesamte Produkt spannungsfrei (hierfür IMMER den Stecker ziehen) und lassen es abkühlen, bevor Sie
Reinigungs- oder Pflegemaßnahmen an dem Produkt vornehmen.
•
Reinigen Sie das Produkt regelmäßig - nur mit einem leicht angefeuchteten, weichen und fusselfreien Tuche. Beachten Sie eventuell
beiliegende Hinweise
10.Entsorgung
•
Elektronik-Altgeräte müssen den öffentlichen Sammelstellen zugeführt werden und dürfen nicht als Hausmüll entsorgt werden
Leuchtmittel Schutzart Schutzklasse
1 x E27 wechselbar max. 25W LED IP44 II
1 x E27 wechselbar max. 25W LED IP44 II
1 x E27 wechselbar max. 25W LED IP44 II
1 x E27 wechselbar max. 25W LED IP44 II
EN Installation and Operating Instructions
Light Pilar Mundan
Art. No. 501000,501001,501002,501003
These operating instructions refer exclusively to the above products.
They contain important informations for the start-up and handling of the luminaire.
Therefore, pay attention to these operating instructions, even if you pass this product on to
third parties
1. Introduction
Dear customer, thank you for deciding to purchase our product.
You have acquired a product from Vollmer, which has been built according to the current state of
technology.
The light fulfils the requirements of effective European and national guidelines
To maintain the condition of the product and to ensure safe operation, you - as the user - must observe the
instructions of this operation manual!
2. Safety Instructions
•
The guarantee becomes invalid if damage occurs due to the failure of not following these operating instructions!
•
We do not accept liability for any consequential damage!
•
Commissioning is strictly prohibited if there are any damages on the luminaire.
•
It´s not allowed to modify the product. Alterations to the light invalidate the guarantee.
•
It´s not allowed to remove the type plate
3. Proper Use
This luminaire is designed for outdoor use.
This product is only intended for lighting purposes and may:
•
only be operated with a voltage of 230V ~50Hz
•
only be connected according to protection class II (two)
•
only be operated on normal or non-flammable surfaces
•
not be subjected to strong mechanical loads or heavy soiling.
4. Before Installation/Commissioning
•
It´s not allowed to operate the luminaire inside the packaging.
•
Remove the luminaire from the packaging carefully.
•
Make sure that the luminaire has not been damaged during transport before taking the luminaire into operation.
It´s not allowed to operate the luminaire if there are any damages to electrical parts. Repairs may only be carried out by a
qualified electrician.
•
Keep packaging materials away from children and pets. Danger of suffocation!
2 von 6 | 04.02.2021