Maintenance; Environmental Protection - Wesco WS8912K Originalbetriebsanleitung

4) 8 lines (making up 2 vertical squares crossed each
other) (See Fig. E4)
Press the operating mode button ("H/V" key) the third time,
the vertical square facing to the side will keep on illuminating,
also 4 green laser beams will be sent out from the emission
port (Front) and make up a vertical square facing frontward.
The 2 vertical squares will cross each other.
5) 12 lines (making up 1 horizontal square + 2 vertical
squares crossed each other) (See Fig. E5)
Press the operating mode button ("H/V" key) the forth time,
the 2 crossed vertical squares will keep on illuminating, and
4 green horizontal laser beams will also be sent out from the
emission port (Top) and make up a horizontal square. Totally
12 lines are launching from the 3 emission ports and make
up 3 crossed squares (1 horizontal and 2 vertical squares).
All the laser beams run and cross at to each other a 90°
angle.
5. L-SHAPED HOLDER (SEE FIG. F1-F3)
This laser level is provided with an L-shaped holder which
offers a stable, height-adjustable support. The two magnets
on the holder can help to position the laser level to vertical
magnetic surface.
To install the L-shaped holder to the tool, first align the
screw of the lock knob (a) on the holder to the holder
mounting hole at the bottom of the tool. Then fasten the
holder to the tool by turning the lock knob (a) clockwise.
Directly place the L-shaped holder with the tool to the
vertical magnetic surface. You can change the height at will.
6. LASER TARGET BOARD
The laser target board provided with the tool can increase
the visibility of the laser beam under unfavorable conditions
(e.g. outdoors with bright sunlight) or at large distances.
The reflective part of the laser target board improves the
visibility of laser lines. The transparent part of the laser
target board helps for the visibility of the laser lines even
from the back of the laser target board.
7. ADJUSTING LASER INTENSITY
When in auto-leveling mode, press the on/off switch once,
the laser beam will become weaker. Press the on/off switch
once again, and the laser beam will be stronger again. You
can choose it to be weaker or stronger accordingly. You can
also use laser target board as required.
8. LOW BATTERY ALARM
An alarm will be triggered when the laser level is in a low
battery condition. The indicator light will turn to red to
indicate that you should charge the battery pack. After that,
the laser level will turn off automatically.
12

MAINTENANCE

1. Store and transport the tool only in the supplied
protective case.
2. Keep the tool clean at all times.
3. Do not immerse the tool into water or other fluids.
4. Wipe off debris using a moist and soft cloth. Do not use
any cleaning agents or solvents.
5. Regularly clean the surfaces at the exit opening of
the laser in particular, and pay attention to any fluff of
fibers.
6. If the tool should fail despite the care taken in
manufacturing and testing procedures, repair should be
carried out by an authorized after-sales service center.
7. While the product has not been used for long time, do
regular inspection on the battery. Please charge and
discharge the battery to extend the service life. When
the battery is low in capacity, charge it as soon as
possible.
8. Any debugging or repair required on this product should
be performed only by authorized service personnel.
9. Use only replacement parts and accessories
recommended by the manufacturer.
10. When the appliance is not in use, store it in a place out
of reach of children.

ENVIRONMENTAL PROTECTION

Waste electrical products must not be disposed
of with household waste. Please recycle where
facilities exist. Check with your local authorities or
retailer for recycling advice.
EN