Klarstein 10029318 Gebrauchsanweisung Seite 7

Then close again with the movable clip suspended from the hub (let it snap shut)
and slide the closure back over it.
The hose must be hooked behind the outer ring so that you can snap the locking
clip shut without force (see above).
STEP 2
Insert the window seal horizontally or vertically into a window gap. If possible
(i.e. without causing irreparable damage and only if removal can be done without
problems), remove the window seal at the appropriate place and guide it around
the insert. If necessary, screw it to the guide rail of the window.
Take the two „halves" of the air outlet and slide them into the opening in the
window seal in an arrow shape so that the barbed indentation almost hooks into
place. Then clamp the hose in the center and fold the two halves together. There
should be a distinct audible and tactile click. The air conditioner should not be
more than 50 cm from the window during this step to avoid any damage caused
by excessive tension or kinks in the hose and to prevent the air conditioner from
tipping over.
Inner ring
Outer ring
EN
7