Status JS750M Originalbetriebsanleitung Seite 6

SAFETY INSTRUCTIONS FOR JIG SAWS
• Use the power tool, accessories and tool bits etc. in accordance with these
instructions, taking into account the working conditions and the work to be
performed. Use of the power tool for op-erations different from those intended could
result in a hazardous situation.
SERVICE
• Have your power tool serviced by a qualified repair person using only identical
replacement parts. This will ensure that the safety of the power tool is maintained.
SAFETY INSTRUCTIONS FOR JIG SAWS
• Your tool is double insulated for additional protection against a possible electrical
insulation failure within the tool.
• Always remove the plug from the mains socket before making any adjustments or
maintenance, including changing the blade.
• Ensure that the lighting is adequate.
• Do not use the saw unless the guards are in place.
• Keep the shoe flat on the work piece.
• Do not put pressure on the saw, such that it slows the motor down. Allow the saw
blade to cut without pressure. You will get better results and you will be taking better
care of your tool.
• Keep the area free of tripping hazards.
• Do not let anyone under 18 years operate this jigsaw.
• Only use blades in good condition.
• Before cutting, check that there is sufficient clearance for the blade under the work
piece.
• Do not touch the blade after operation. It will be very hot.
• Keep your hands away from under the work piece.
• Never use your hands to remove sawdust, chips or waste close by the blade.
• Rags, cloths, cord, string and the like should never be left around the work area.
• Avoid cutting nails. Inspect the work piece and remove all nails and other foreign
objects before beginning sawing.
• Support the work properly.
• Never reach over the blade to remove waste or off cuts.
• Do not attempt to free a jammed blade before first switching off the machine.
• If you are interrupted when operating the saw, complete the process and switch off
before looking up.
• Periodically check that all nuts, bolts and other fixings are properly tightened.
• Do not store materials or equipment above a machine in such a way that they could fall
into it.
EN
6