Commend TSSH 07V Kurzanleitung

Surface-Mount Kit TSSH 07V
Extent of supply
ƒ Flush-mount box TSFB 07V
ƒ Mounting kit (4 x screws, dowels and washers)
ƒ Short Reference
Mounting
2a
1
..... Surface mount box (Metal)
Mounting via mounting kit
Note: - Take care of the mounting direction ("UP" icon).
- Please take care of the correct mounting direction: The microphone has to be located at
the bottom edge of the terminal and it may not be covered.
For the position of the microphone, please see the short reference of the touch terminal
2
..... IP 65 cable feed through
Installation cable feed through.
Note: - Per cable one cable feed through has to be used!
- It is only possible to use cables with a diametre of 2 - 7mm (0.08 - 0.28 in)
- The opening of the cable feed-in has to be smaller than the diameter of the used cable!
If the cable inlet on the backside of the surface mount box is used,
2a
the cable must be inserted in the cable feed through before mounting
the surface mount box.
2b If the cable inlet on the bottom of the surface mount box is used,
the cable feed through from the front panel box must be used (not pictured).
Note: - Cable feed throughs for the surface mount box have to be
ordered separately!
1
2b
Measurements
Measurements in mm (inch), not to scale!
45*
(1.77)
3*
(0.12)
~1 40
(0.04) (1.57)
Attention
Observe the precautions for handling of electrostatic sensitive devices!
The device may be only installed by authorised engineers.
Manufacturer's reference
This equipment fulfils the requirements of the
EU low voltage directive 2006/95/EG.
Therefore this equipment is CE-labelled.
Type: D-BZ-TSSH07V, Version: 1.1/0214
80 (3.15)
160 (6.3)
120 (4.72)
80 (3.15)
*Measurements with Intercom Terminal