VOLTCRAFT 2338742 Bedienungsanleitung Seite 2

Operating Instructions
USB charger
Item No. 2338742 / SPS-2100m / USB cable with micro-USB plug
Intended Use
The product is supplied with a USB cable with a micro-USB plug for charging mobile devices with a micro-
USB connection.
The charger is connected to the household mains and is protected against overload and short circuits.
It is intended for indoor use only. Do not use it outdoors. Contact with moisture, e.g. in bathrooms, must be
avoided under all circumstances.
For safety and approval purposes, you must not rebuild and/or modify this product. If you use the product
for purposes other than those described above, the product may be damaged. In addition, improper use
can result in short circuits, fires, electric shocks or other hazards. Read the instructions carefully and store
them in a safe place. Make this product available to third parties only together with its operating instructions.
This product complies with the statutory national and European requirements. All company names and prod-
uct names are trademarks of their respective owners. All rights reserved.
Delivery Content
• USB charger
• USB cable with micro-USB plug
• Operating instructions
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR
code shown. Follow the instructions on the website.
Explanation of Symbols
The symbol with the lightning in the triangle is used if there is a risk to your health, e.g. due to an
electric shock.
The symbol with the exclamation mark in the triangle is used to indicate important information in
these operating instructions. Always read this information carefully.
The arrow symbol indicates special information and advice on operation.
Safety Instructions
Read the operating instructions carefully and especially observe the safety information.
If you do not follow the safety instructions and information on proper handling in this
manual, we assume no liability for any resulting personal injury or damage to property.
Such cases will invalidate the warranty/guarantee.
a) General Information
• The device is not a toy. Keep it out of the reach of children and pets.
• Do not leave packaging material lying around carelessly. This may become dangerous playing
material for children.
• Protect the appliance from extreme temperatures, direct sunlight, strong jolts, high humidity,
moisture, flammable gases, steam and solvents.
• Do not place the product under any mechanical stress.
• If it is no longer possible to operate the product safely, take it out of operation and protect it
from any accidental use. Safe operation can no longer be guaranteed if the product:
- is visibly damaged,
- is no longer working properly,
- has been stored for extended periods in poor ambient conditions or
- has been subjected to any serious transport-related stresses.
• Please handle the product carefully. Jolts, impacts or a fall even from a low height can dam-
age the product.
• Never use the product immediately after it has been brought from a cold room into a warm
one. The condensation generated could destroy the product. There is also a risk of a fatal
electric shock! Allow the product to reach room temperature before connecting it to the power
supply and putting it to use. This may take several hours.
• Remove the product from the mains socket and the connected device when you are not
using it.
• The product generates heat during use. Ensure that there is sufficient ventilation and do not
cover the product during use.
• Do not short-circuit the USB output.
• The mains socket that the device is plugged into must be easily accessible.
• As power supply, only use the supplied mains adaptor.
• Only connect the power adaptor to a normal mains socket connected to the public supply.
Before plugging in the power adaptor, check whether the voltage stated on the power adaptor
complies with the voltage of your electricity supplier.
• Never connect or disconnect power adaptors if your hands are wet.
• Never unplug the power adaptor from the mains socket by pulling on the cable; always use
the grips on the plug.
• When setting up the product, make sure that the cable is not pinched, kinked or damaged
by sharp edges.
• Always lay the cables so that nobody can trip over or become entangled in them. This poses
a risk of injury.
• For safety reasons, disconnect the power adaptor from the mains socket during storms.
• Never leave the product and the connected device unattended during use.
• Consult an expert when in doubt about the operation, safety or connection of the appliance.
• Maintenance, modifications and repairs must only be completed by a technician or an au-
thorised repair centre.
• If you have questions which remain unanswered by these operating instructions, contact our
technical support service or other technical personnel.
b) Connected devices
• Also observe the safety and operating instructions of any other devices which are connected
to the product.
Operation
The maximum power consumption must not be exceeded. Pay attention to the information in the
technical data.
1. Connect the micro-USB plug to the charging socket on your mobile device.
2. Insert the USB-A plug on the USB charging cable into the USB socket on the charger.
3. Connect the charger to a suitable mains socket.
4. Charging begins.
5. When charging is complete, remove the charger from the mains socket before removing the USB charg-
ing cable from the mobile device.
Care and Cleaning
• Disconnect the product from the mains before each cleaning.
• Do not use any aggressive cleaning agents, rubbing alcohol or other chemical solutions as they can
cause damage to the housing and malfunctioning.
• Clean the product with a dry, fibre-free cloth.
Disposal
Electronic devices are recyclable waste and must not be disposed of in the household waste.
At the end of its service life, dispose of the product in accordance with applicable regulatory
guidelines.
You thus fulfill your statutory obligations and contribute to the protection of the environment.
Technical Data
Input voltage / current ............................................100 – 240 V/AC, 0.28 A
Input AC frequency ................................................50 – 60 Hz
Output voltage .......................................................5.0 V/DC
Output current ........................................................2.1 A
Output power .........................................................max. 10.5 W
Average active efficiency .......................................82.81 %
Efficiency at low load (10%) ..................................71.53 %
No load power consumption ..................................0.07 W
Model identifier:
Commercial registration number:
Manufacturer:
Protection class .....................................................II
Operating conditions ..............................................0 to + 35 °C, 25 - 85 % RH (non-condensing)
Storage conditions .................................................-10 to +55 °C, 20 - 90 % RH (non-condensing)
Dimensions (W x H x D) ........................................approx. 82 x 24 x 46 mm
Weight ...................................................................approx. 43 g
This is a publication by Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau (www.conrad.com). All rights in-
cluding translation reserved. Reproduction by any method, e.g. photocopy, microfilming, or the capture in electronic data
processing systems require the prior written approval by the editor. Reprinting, also in part, is prohibited. This publication
represent the technical status at the time of printing.
Copyright 2020 by Conrad Electronic SE.
SPS-2100m
HRB 3896
Conrad Electronic SE, Klaus-Conrad-Str. 1, D-92240 Hirschau
*2338742_V1_1220_02_mxs_m_en