Herunterladen Inhalt Inhalt Diese Seite drucken

Warranty - Petsafe PTY19-16961 Gebrauchsanleitung

Vorschau ausblenden Andere Handbücher für PTY19-16961:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 22
Operating instructions
One Time Play:
Find the power button on the top of the toy. Press the button (C) and hold for one second, then
release, to power on.
The toy will turn on and play for 10 minutes, then power off automatically.
To end the play session before 10 minutes, press the power button and hold for one second
and release.
Play All Day:
Find the power button on the top of the toy. Press the button for 2-4 seconds, then release, to power on. The toy will beep three
times to let you know when Play All Day mode is activated.
Play All Day mode lasts for a 6.5-hour time period. During this mode, the toy will:
Play 10 minutes, rest for 2 hours. During rest time, motion sensor is on.
Play 10 minutes, rest for 2 hours. During rest time, motion sensor is on.
Play 10 minutes, rest for 2 hours, power off. During rest time, motion sensor is on.
During rest time in Play All Day mode, if motion is detected within 90-120 centimetres in front of the toy, it will turn on for
2 minutes. Once the cat walks away, the toy will rest again within 2 minutes. Note: the motion sensor is at the front of the toy.
Be sure to place the toy in a safe play area where the cat may walk by the front of it. There is a delay of 25 seconds after the
2 minutes of play before more motion is detected.
To power off while in Play All Day mode, press the power button on the top of the toy quickly once, then release.
To replace the feather cluster:
1. Press and hold the power button until you hear a total of five beeps,
and release. Immediately press and release the button again. This will
cause the feather cluster to stay in a fixed position for replacement.
2. Pull the feather cluster firmly, until it pops off the retaining post (D). It
will stretch a bit before it pops off. Take note of the orientation of the
plastic clip end.
3. To replace, hold new feather cluster, being careful to orient the plastic
clip end as pictured. Line it up with the retaining post, and push until
you feel it clip back on (E). You should be able to gently pull on the
feather to confirm that it is firmly clipped to the retaining post.
To ensure proper functioning
Do not mix old and new batteries.
Do not mix standard, alkaline or rechargeable batteries.
Do not use rechargeable batteries.
Exhausted batteries should be removed immediately. Do not dispose of batteries with household waste.

Warranty

Two-year non-transferable limited warranty: This product has the benefit of a limited manufacturer's warranty. Complete
details of the warranty applicable to this Product and its terms can be found at www.petsafe.net and/or are available by contacting
your local Customer Care Centre.
Europe – Radio Systems PetSafe Europe Ltd., 2nd Floor, Elgee Building, Market Square, Dundalk, Co. Louth, A91 YR9X Ireland
Canada – Radio Systems Corporation, 10427 PetSafe Way, Knoxville, TN 37932 USA
Australia/New Zealand – In compliance with Australian Consumer Law, Warranties Against Defects, effective 1st January
2012, warranty details of this Product are as follows: Radio Systems Australia Pty Ltd. (hereinafter referred to as "Radio Systems")
D
petsafe.com
C
E
3

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis