BEARWARE 300791 Bedienungsanleitung Seite 11

6. Re-assigning the channels
To assign a new channel to a wireless socket, please press the "ON-OFF" button of
the desired socket for 3 seconds. Then, the LED starts to flash.
A channel can now be assigned to the wireless socket. To do this, press one of the
"ON" buttons on the channels 1-4 on the remote control. Then the LED of the wire-
less socket starts flashing at brief intervals and subsequently goes out. The wireless
socket has now been assigned to that channel, whose "ON" button you are using
on your remote control.
Note: If you want to assign the channels for all the sockets, press and hold the
"ALL OFF" button on the remote control for 3 seconds. All the LEDs of the wireless
sockets start to flash.
7. Ambient conditions
Altitude
Temperature
Relative humidity
Transient power surge
Degree of soiling
There are no special ventilation requirements for this product. For safety reasons,
ensure that the product is not covered by a blanket etc. once it is being used.
8. Warranty
The manufacturer provides a warranty of two years for this product with regards
to workmanship and material. Repairs should only be carried out by an authorized
customer service centre. The original sales document should be enclosed as proof.
English
up to 2000 m
0°C to 35°C
• up to 30°C: maximum 80%
• 30°C - 40°C: maximum 50%
CAT II
2
11